Vitek VT-6403 BK - Инструкция (Страница 7)

English
7
Switching data receipt channels
Press the CHANNEL button to switch data receipt channels from remote sensors
(Ch 1, Ch , Ch ), indoor (IN), switching on cycle displaying of temperature
data from different channels (
).
Temperature change tendencies
Temperature change tendencies are displayed as arrows (growing, constant,
falling down) near the corresponding data.
Viewing minimal/maximal temperature value
At each press the MEM button the switching between displaying of the following
parameters appears:
•
Current temperature
• Minimal temperature
• Maximal temperature
Reset of the minimal/maximal temperature values
Press and hold the MEM button for more than  seconds to clear memory of all
the channels
Note: during operation of the remote sensor at temperature below 0°C voltage
in the batteries can drop, thus reducing the effective radius of its emitter.
SETTING THE DATE AND THE CURRENT TIME
The base unit can display current time and the date. To switch between the cur-
rent time, date and day press the CLOCK button.
To set the current time and the date press and hold the CLOCK button for more
than  seconds. You can select time displaying format (1 hours or 4 hours),
set the current time (hours: minutes) and the date.
Use the
“ ▼/▲” to enter the parameters. To confirm the entered parameters
press the CLOCK button.
SETTING ALARM ACTUATION TIME
To switch on the alarm mode press the ALARM button. The “AL” symbol will ap-
pear on the LCD-display. To switch on/off the alarm press the button once again
when the alarm is on, the symbol will appear on the LCD-display.
To set the alarm actuation time, press and hold the ALARM button. Digits of
hours will start flashing
. Use the “ ▼/▲” buttons to set the actuation hour. To
confirm the setting press the ALARM button. Digits of minutes will start flashing .
6403IM.indd 7 19.03.2008 14:13:46