Vitek VT-6404 PR - Инструкция (Страница 5)

English
5
DESCRIPTION
BASE UNIT
1. Display
Displaying of current time (a), date
(b), sunrise (c) and sunset time
(d), temperature and humidity
values from the remote sensor (e)
and inside the room (f), pressure
(g), lunar phases (h) and symbolic
weather forecast (i).
. The Max/Min/+ button.
Displaying of maximal/minimal
temperature, setting of current
time, alarm time, date, as well as
temperature and humidity value
limits.
. The Mode button
Switching between the current
time modes Clock 1/Clock ,
Alarm 1/Alarm  modes, entering
the set up mode.
. The Alarm/Channel/°C/°F button
Switching on/off of Alarm 1/
Alarm  modes, signal switching
from the remote sensors (from
1 till ).
5. The Select/- button
Setting the current time, alarm,
date as well as temperature and
humidity value limits.
6. The Snooze/Light button
Activation of the snooze function
and switching of the backlight of
the display.
7. Battery compartment (for three
“АА” batteries)
8. Wall-mount holder
9. Table stand
REMOTE TEMPERATURE AND HU-
MIDITY SENSOR
10. LCD-display reflect temperature
and humidity values
11. The SET button
Entering of HOUSE CODE,
adjusting of channels.
1. External wire sensor jack
1. The
°C/°F button
Switching between the Celsius
and Fahrenheit scales, change of
channels and house code.
1. Battery compartment (for three
“АА” batteries)
15. Wall-mount holder/table stand
16. External wire sensor
BEFORE YOU BEGIN
For best operation insert the batteries
firstly in the remote sensor and then in
the base unit.
Placing batteries in the remote
sensor
1. Unscrew the screws on the battery
compartment lid. Insert  batteries
(“АА”, 1.5 V), following the polarity.
. The HOUSE CODE will start
flashing on the LCD-display for
8 seconds. HOUSE CODE – is a
frequency signal, sent from the
remote sensor to the base unit.
All remote sensors in your system
should have the same HOUSE
CODE.
6404IM.indd 5 20.08.2008 15:57:03