Binatone JE-8500 - Инструкция (Страница 5)

5
ENGLISH
! Do not use the appliance if it has mechanical defects (dents,
cracks etc.), get it checked by the nearest authorized service
center.
! To avoid mechanical defects and damage, take care during
the appliance transportation.
SPECIAL SAFETY MEASURES
! Before preparing food always remove stones
and other tough tissues.
! Before switching the juicer on always check if
the lid is properly installed and fixed.
! Do not open the lid latches or remove the lid
when the juicer is on. Switch off the appliance
wait for the motor to stop and then open the appliance.
! Your juicer is equipped with an automatic protection system;
which stops the operation if the juicer parts are not assembled
properly.
! To push the fruit and vegetables inside use only the pusher that
comes with the juicer. Do not use foreign objects, and never use
your fingers for that.
! Do not overload the juicer; do not use excess force to get the fruit
through.
! Do not let foreign objects get into the fruit inlet.
! Only run the juicer for 2 minutes at a time, leave the appliance
for a 5 minute break before using again.
! If your juicer becomes blocked, switch it off, unplug and remove
pulp of fruit and vegetables.
! Always unplug after use and before disassembling and clean-
ing.
! Do not use the juicer if the grater-filter or its housing is dam-
aged.
! Solid fruit and vegetebles should be put into the tube of the
large pusher (3).
! If the juice stops coming out of the nozzle, it means that the
juicer is blocked. Stop loading or you may damage the motor.
Then switch the juicer off, unplug and clean as described in the
cleaning instruction below; after that you may resume the juice
preparation. Please note; processing soft vegetables and fruit
means you will need to clean the juicer more often.
DESCRIPTION OF THE
APPLIANCE
Pic. A:
1. Small pusher
2. Large pusher
3. Feeder tube of the large pusher
4. Feeder tube of the lid
5. Grater/filter
6. Pulp container
7. Anti-drip system (juice stopper)
8. Juice spout
9. Safety clamps