WORX Tools WU376.2 - Инструкция (Страница 14)

Cordless Hammer Drill ENG
tight screw or continue working when the
battery energy has expired (See Fig H). For
manual screwdriver purposes, the screw head
is automatically locked when the tool is off.
PROBLEM SOLUTION
1. WHY DOES THE DRILL NOT TURN ON
WHEN YOU PRESS THE SWITCH?
The forward and reverse switch, which is on top
of the trigger, is positioned in the lock function.
Unlock the forward and reverse switch putting
it into the required rotation position. Push the
trigger and the drill will start to rotate (See C).
2.THE DRILL STOPS BEFORE THE SCREW
IS COMPLETELY TIGHTENED. WHY?
Verify the torque position of the torque adjusting
ring, you can find the torque-adjusting ring
between the chuck and the drill body. Position
1 is the lowest torque (screw driving force) and
position 23 is the highest torque (screw driving
force). Position 24 is for drill operation. Regulate
the torque adjusting ring to a higher position to
reach the best result.(See Fig E.1 & E.2)
3. I CANNOT FIT THE BATTERY INTO THE
BATTERY CHARGER. WHY?
The battery can be inserted into the charger
only in one direction. Turn the battery around
until it can be inserted into the slot, the red
LED light should turn on when the battery is
charging (See A).
4. REASONS FOR DIFFERENT CHARGING
TIMES
Your charge time can be affected by many
reasons which are not defects in your product.
If the battery pack is only partly discharged it
may be re-charged in less than 1 hour. If the
battery pack and ambient temperature are very
cold then re-charging may take 1-1.5 hours. If
the battery pack is very hot it will not re-charge
because the internal temperature safety cutout
will prevent it. If the battery pack is very hot
you must remove your battery pack from the
charger and allow your battery pack to cool first
to ambient temperature and then recharging
can be started. If you charge a second battery
pack immediately after the first then the charger
can be overheated. Always allow at least 15
minutes rest between battery pack charging.
5. REASONS FOR DIFFERENT BATTERY
PACK WORKING TIMES
Charging time problems, as above, and having
not used a battery pack for a prolonged time
will reduce the battery pack working time.
This can be corrected after several charge and
discharge operations by charging & working
with your drill. Heavy working conditions such
as large screws into hard wood will use up the
battery pack energy faster than lighter working
conditions. Do not re-charge your battery pack
below 0ºC and above 30ºC as this will affect
performance.
MAINTENANCE
Your tool requires no additional lubrication or
maintenance. There are no user serviceable
parts in your tool, battery pack or changer.
Never use water or chemical cleaners to clean
your tool. Wipe clean with a dry cloth. Always
store your tool in a dry place. Keep the motor
ventilation slots clean. If you see some sparks
flashing in the ventilation slots, this is normal
and will not damage your tool.
ENVIRONMENT
PROTECTION
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your Local Authority or retailer for
recycling advice.
15 14
UKR-WU376 WU376.1 WU376¡ª060726.indd 14 2006-7-26 14:05:44