WORX Tools WU645 - Инструкция (Страница 10)

Palm Sander ENG
5.PAPER PUNCH
If using sanding paper without dust holes,
use the paper punch (7) to perforate the holes
to ensure correct dust extraction. Position the
punch over the base-plate (8) with the punch
sides on the edges of the base-plate (see C).
Press the punch into the base-plate to punch
holes into the sanding paper. Then remove the
punch and check all the holes have been formed
correctly.
6. DUST BAG
Always operate your sander with the dust bag
fitted. For the best performance always empty
the dust bag in time. Open the zip and empty
the dust from the bag. To remove the bag ,slide
the mounting bracket out and away from the
sander ( (See D). To refit the bag, firmly push
the mounting bracket into the location on the
sander housing (See E).
For best performance always empty the dust
bag when it is half full.
7. FLUSH SANDING FACILITY
Your sander can sand flush on three sides of the
base-plate which allows easy access to corners
and edges of moulding (see F).
8. ORBITAL SANDING
Your sander operates in small circular rotations
which allows efficient material removal.
Operate your sander in long sweeping
movements across your workpiece and even
across the grain. For a finer finish, always use a
fine grain sandpaper and only move the sander
in the direction of the grain and never across
the grain.
Do not allow your sander to remain in the same
position otherwise you will remove material
and create and uneven surface.
WORK HINTS FOR YOUR
PALM SANDER
If your power tool becomes too hot, run no load
for 2-3 minutes to cool the motor.
Always ensure the work-piece is firmly held or
clamped to prevent movement.
Any movement of the material may affect the
quality of the sanding finish.
Start your sander before sanding and turn off
only after stopping sanding. For best results
sand wood in the direction of the grit.
Do not start sanding without sandpaper fitted.
Do not allow the sandpaper to wear away, it will
damage the base-plate. The guarantee does not
cover base-plate wear and tear.
Use coarse grit paper to sand rough surfaces,
medium grit for smooth surfaces and fine grit
for the final surfaces. If necessary, first make a
test on scrap material.
Use only good quality sandpaper.
The sanding efficiency is controlled by the
sandpaper not the amount of force you apply
to the tool. Excessive force will reduce the
sanding efficiency and cause motor overload.
Replacing the sanding paper regularly will
maintain optimum sanding efficiency.
MAINTENANCE
Your power tool requires no additional
lubrication or maintenance. There are no user
serviceable parts in your power tool. Never use
water or chemical cleaners to clean your power
tool. Wipe clean with a dry cloth. Always store
your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working control
free of dust. If you see sparks flashing in the
ventilation slots, this is normal and will not
damage your power tool.
ENVIRONMENTAL
PROTECTION
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your local authorities or retailer for
recycling advice.
11 10
WU645-M-060818.indd 10 2006-8-18 15:43:43