Petsafe In-Ground Fence PRF-3004XW-20 - Инструкция (Страница 137)

OPeRaTiNG GuiDe
sTeP 1
install the Fence Transmitter
Place the Fence Transmitter:
•In a dry, well ventilated, protected area
(1a, 1B).
•In an area where temperatures do not fall below freezing (e.g., garage, basement, shed).
•Secured to a stationary surface using appropriate mounting hardware (not included). A mounting template is included in the back of
this guide.
•At least 1 m from large metal objects or appliances as these items may interfere with the signal consistency (1C).
Once you have mounted the Fence Transmitter, the Boundary Wire must exit the building. This can be accomplished via a window or through
a hole drilled through the wall. Ensure the drill path is clear of any utilities.
Make sure the Boundary Wire is not cut off or pinched by a window, door, or garage door, as this can damage it over time and create
a wire break. To prevent fires and electrical hazards, install the Fence Transmitter in buildings that are in accordance with state and local
electrical codes.
Risk of Electric Shock. Use the Fence Transmitter indoors in a dry location only.
1a 1B
1 m
(3ft)
1C
1 m
sTeP 2
lay Out the system
Underground cables can carry high voltage. Have all underground cables marked before you dig to bury your wire.
In most areas, this is a free service. Avoid these cables when you dig.
Basic Planning Tips
•The Boundary Wire MusT start at the Fence
Transmitter and make a continuous loop back (2a).
•Design a layout that is suitable for your property.
Sample layouts are provided in this section, and a
grid for designing your layout is provided in the back
of this guide.
•Twisting two sides of the Boundary Wire cancels the
signal and allows your pet to cross over that area
safely. Plastic or metal piping will not cancel the
signal. Twist the Boundary Wire 30 times per metre
to cancel the signal
(2a).
30 Twists/m
2a 2B
www.petsafe.net 137
EN
NO
RU
SV
DA
FI