Microlife BP W100 - Инструкция (Страница 8)

6
How not to store a reading
Press the ON/OFF button 1 while the reading is being displayed.
Keep the button pressed until «M» AL is flashing and then release it.
Confirm by pressing the M-button again.
6. Setting the Alarm Function
This instrument allows you to set 2 alarm times at which an alarm
signal will then be triggered. This can be a useful aid, for instance as
a reminder to take medication.
1. To set an alarm time, press the time button 6 (the instrument
must have been switched off beforehand) and immediately after-
wards the M-button 5 and hold both down until the bell symbol
AK appears in the bottom left of the display. Then release both
buttons. The flashing «1» in the display indicates that the first
alarm time can now be set.
2. Press the time button to set the hours – the hour display flashes
and pressing the M-button allows you to set the alarm hour. To
confirm, press the time button.
3. The minute display will now flash. The minutes can be set using
the M-button. To confirm, press the time button again.
4. The bell symbol will now flash. Use the M-button to select whether
the alarm time is to be active (bell) or inactive (crossed-out bell).
To confirm, press the time button.
 To set a second alarm time, proceed as above but if the «1» flashes,
press the M-button to select «2» and confirm with the time button.
 An active alarm time is indicated by the bell symbol in the display.
 The alarm will sound at the set time every day.

To switch-off the alarm when it is sounding, press the ON/OFF
button 1.
 To permanently switch off the alarm, proceed as above and select the
crossed-out bell symbol. This will then disappear from the display.
 The alarm times must be re-entered each time the batteries are
replaced.
7. Battery Indicator and Battery change
Low battery
When the batteries are approximately ¾ empty the battery symbol AO
will flash as soon as the instrument is switched on (partly filled battery
displayed). Although the instrument will continue to measure reliably,
you should obtain replacement batteries.
Flat battery – replacement
When the batteries are flat, the battery symbol AO will flash as soon
as the instrument is switched on (flat battery displayed). You cannot
take any further measurements and must replace the batteries.
1. Open the battery compartment 3 by pulling off the cap.