Data memory, Viewing the stored values, Memory full – Инструкция по эксплуатации Microlife BP W100

Страница 7: Clearing all values

Advertising
background image

5

BP W100

EN

You can stop the measurement at any time by pressing the

ON/OFF button (e.g. if you feel uneasy or an unpleasant pres-

sure sensation).

4. Appearance of the Heart Arrhythmia Indicator for

early Detection

This symbol AM indicates that certain pulse irregularities were detected

during the measurement. In this case, the result may deviate from your

normal blood pressure – repeat the measurement. In most cases, this is

no cause for concern. However, if the symbol appears on a regular basis

(e.g. several times a week with measurements taken daily) we advise you

to tell your doctor. Please show your doctor the following explanation:

5. Data Memory

At the end of a measurement, this instrument automatically stores

each result, including date and time.
Viewing the stored values

Press the M-button 5 briefly, when the instrument is switched off.

The display first shows «M» AL and then a value, e.g. «M 17». This

means that there are 17 values in the memory. The instrument then

switches to the last stored result.

Pressing the M-button again displays the previous value. Pressing

the M-button repeatedly enables you to move from one stored value

to another.
Memory full

ƽ

When the memory has stored 200 results, the memory is full.

From this point onwards, a new measured value is stored by

overwriting the oldest value.

Clearing all values

If you are sure that you want to permanently remove all stored

values, hold down the M-button (the instrument must have been

switched off beforehand) until «CL» appears and then release the

button. To permanently clear the memory, press the M-button while

«CL» is flashing. Individual values cannot be cleared.

Information for the doctor on frequent appearance of the

Arrhythmia indicator
This instrument is an oscillometric blood pressure monitor that also

analyses pulse frequency during measurement. The instrument is

clinically tested.

The arrhythmia symbol is displayed after the measurement, if pulse

irregularities occur during measurement. If the symbol appears more

frequently (e.g. several times per week on measurements performed

daily) we recommend the patient to seek medical advice.

The instrument does not replace a cardiac examination, but serves

to detect pulse irregularities at an early stage.

Advertising