KORTING OGG741RI - Инструкция (Страница 20)

20
INSTALLATION
After removing the appliance from the pack-
aging, make sure that it is undamaged and that
the electrical lead is in perfect condition.Other-
wise, contact your dealer before putting the ap-
pliance into operation.
IMPORTANT: The gas and electricity con-
nections and any adjustments must be
made by specialised staff.
The manufacturer declines all responsibil-
ity for any type of damage caused by failure to
comply with the regulations in force or negligent
installation of the appliance.
Gas connection
The connection to the mains gas supply or
the gas cylinder must be made in accordance
with the installation norms in force.
Remember that this appliance may only be
installed and used in rooms permanently venti-
lated in accordance with the norms in force.
In other words, the rooms must have open-
ings on outside walls or suitable ducts which
allow correct natural or forced ventilation, per-
manently ensuring adequate intake of the air
necessary for proper combustion and the dis-
charge of stale air. If this is the only gas appli-
ance in the room, a hood must be placed above
it for natural, direct removal of stale air, with a
straight vertical fl ue of length at least twice its
diameter, with a minimum cross-section of at
least 100 cm2.
To allow the indispensable intake of fresh
air into the room, a suitable opening of at least
100 cm2 leading directly outdoors must be pro-
vided close to fl oor level, so that it cannot be
obstructed from the inside or outside of the wall
and does not impede proper burner combustion
or the regular elimination of stale air; it must be
at least 180 cm below the level of the discharge
opening.
In all other cases (i.e. when there are other
gas appliances in the same room or direct
natural ventilation is not possible and indirect
natural ventilation or forced ventilation has
to be provided) call in a qualifi ed specialist,
who will install the appliance and construct
the necessary ventilation system in strict ac-
cordance with the requirements of the norms
in force.
Pressure regulators for LPG must comply
with the norms in force.
Provide a stop tap between the gas supply
and the appliance (accessible with the appli-
ance installed).
Make the connection directly to the 1/2” el-
bow on the gas hose, using rigid connection
pipes in accordance with the norms in force,
such as copper or lead iron, or using continu-
ous-wall steel hoses.
Avoid tight bends and take care not to crush
the hose.
In addition, pipes must not apply stresses of
any kind to the appliance.
Check that the connection is airtight using
soapy water.
Warning: do not use fl ames to check any
gas leakages.
Electrical connection
Electric connection has to be done according
to rules and law provisions in force. Before do-
ing the connection, check the following:
The electric power and sockets are suitable to
maximum power of the oven. (See data plate
on the appliance).
WARNING: THIS APPLIANCE MUST BE
EARTHED.
The appliance’s electrical safety can only be
guaranteed when it has been correctly con-
nected to a properly earthed power supply, as
laid down in the regulations for electrical safety.
Important: the manufacturer cannot be held re-
sponsible for any damage to persons or objects
due to the lack of an earth connection.
Never use reducers, adaptors or branches for
connections.