Инструкция по эксплуатации ZELMER 28Z016
Страница 54
54
GW28-006_v01
Self-cleaning
This function removes the scales and minerals built up in the Steam
Chamber. The iron will remain in the best condition if this function is
performed at least once a month or more regularly depending on the
hardness of the water used.
Fill the water tank with demineralised water, or distilled water. (See
–
How To Fill Water)”. Fill it up to the half.
Connect the iron to a suitable mains supply outlet (See the item
–
„Preparation for operation”).
Turn the
–
Temperature Dial (9) in clockwise direction to „MAX“
position.
Control light (4)
–
glows, indicating that the iron is on.
Control light goes off when the required temperature is reached. The
–
iron is now ready for use.
Wait for one more cycle; pilot light glows and goes off.
–
After finishing move the
–
Temperature Dial (9) in anti-clockwise
direction to „
MIN”; the iron is switched off.
Disconnect the iron from mains supply outlet.
–
Hold the iron horizontally over a sink.
–
Move the
–
Steam Control Knob (7) to self-cleaning
position
(Descaling).
Steam and boiling hot water will drain from the holes on the soleplate
–
washing away the scales and minerals that have built up inside the
Steam Chamber.
Gently move the iron back and forth until the water tank is empty.
–
When Self-Cleaning is complete, release the
–
Self-Cleaning Knob (7).
Rest your iron back on its heel rest and allow to fully cool down.
–
Wipe the soleplate with a cold damp cloth.
–
Caution!
Keep skin/body away from the hot water.
Draining the water
Move the
–
Steam Control Knob (3) to
position.
Disconnect the iron from mains supply
–
outlet.
Press the
–
Burst of Steam Button (4),
to release any trapped water when the
soleplate still hot.
Press the
–
Spray Buttons (5), to release
any trapped water.
Turn the iron upside down and gently
–
shake it to remove the remaining water.
Before storage make sure that Steam Control Knob (7) is in
position.
Cleaning and maintenance
Disconnect the iron from mains supply outlet.
–
The iron should get cool completely before cleaning.
–
Use a damp cloth and gentle washing liquid for cleaning.
–
Do not use aggressive detergents like cream, milk, paste etc. to
–
clean the casing. They can remove graphic symbols such as: scales,
marking, caution signs, etc.
Never use sharp or rough objects to remove the deposits on the sole
–
plate.
Never use any abrasive, vinegar or descaling agents to clean the iron.
–