ZELMER 28Z016 - Инструкция (Страница 51)

51 GW28-006_v01
The appliance is not intended to be operated by means of an external –
timer or separate remote-control system.
Do not leave the appliance unattended when it is connected to a mains –
supply outlet or it is hot.
The iron is not to be used if it has been dropped, if there are visible –
signs of damage or if it is leaking.
If you do not use the iron, even for short time, switch it off, turning –
Temperature Dial in anti-clockwise direction to „ MIN”.
If you do not use the iron, even for short time, switch the steam function –
off, setting the knob on position.
Never iron and clothes or fabrics that are being worn by human or –
pets.
Never direct the steam to human or pets. –
Use self-cleaning function at least once a month. –
Hints for ironing
1. Sort out the articles to be ironed according to the type of fabric. This
will minimize the frequency of temperature adjustment for different
garments.
2. Test ironing a small area on the backside or inside the garment if you
are unsure about the type of fabric. Start with a low temperature and
increase gradually.
3. Wait for about three minutes before ironing heat sensitive fabrics.
Temperature adjustment needs certain time to reach the required level
no matter it is higher or lower.
4. Delicate fabrics such as silk, wool, velour, etc. are best ironed with an
ironing cloth to prevent shine marks.
5. You may need a few times of press to activate the spray, burst and
vertically burst function.
6. Read the garment labels and follow the manufacturer’s ironing
instructions which are often shown by symbols similar to the
following:
Temperature settings
○ Acetate
○ Elastics
○ Polyamide
○ Polypropylene
○ Cupro ○ Triacetate
○ Polyester ○ Viscose
○ Proteins ○ Wool
○ Silk
○ Cotton
○ Linen
Technical data
The iron technical parameters are included at the name plate. The iron is
I class appliance, equipped with supplying cord and plug with grounding.
ZELMER iron meets the requirements of effective standards.
The appliance meets the requirements of the following directives:
Low Voltage Device (LVD) – 2006/95/EC. –
Electro- Magnetic Compatibility (EMC) – 2004/108/EC. –
The product is marked with CE symbol on the name plate.
Get to know your iron
1. Sole plate
2. Temperature Dial
3. Dial Pointer
4. Control light (red)
5. Water spraying nozzle
6. Water inlet cover
7. Steam control/
self-cleaning knob
8. Water Spray Button
9. Burst of steam button
10. Cord grommet
11. Water vessel