Инструкция по эксплуатации ZELMER 28Z016
Страница 53
53
GW28-006_v01
After finishing m
–
ove the
Temperature Dial
(2) in anti-clockwise direction to „MIN”; the
iron is switched off.
Move the
–
Steam Control Knob (7) to
position.
Disconnect the iron from mains supply outlet.
–
When the iron gets cool completely, store it
–
vertically in a safe place.
Burst of steam
– Always follow the garment manufacturer’s
ironing instructions mentioned at the garment label.
This function provides extra amount of steam to remove stubborn wrinkles
at clothes and hanging garments.
Unwind and straighten the power cord.
–
Fill the water tank with demineralised water or distilled water. (See
–
How To Fill Water)”.
Connect the iron to a suitable mains supply outlet.
–
Move the
–
Steam Control Knob (7) to selected position, in order to set
the amount of steam.
Turn the
–
Temperature Dial (2) in clockwise direction to ●●● position.
See the item „Preparation for operation”.
Control light (4)
–
glows, indicating that the iron is on.
Control light goes off when the required
–
temperature is reached. The iron is now
ready for use.
Press the Burst of Steam Button
–
(9) once
– steam will shoot from the holes of the
soleplate.
For stubborn wrinkles, wait a few seconds
–
before pressing the Burst of Steam Button
(9) again. Most wrinkles can be removed
within three presses.
ATTENTION:
It may be necessary to press the burst of steam button a few times
to start this function.
For optimum steam quality, do not operate the Burst Of Steam more
than three times after the pilot light goes off.
Burst of steam in vertical position
– Always follow the garment
manufacturer’s ironing instructions mentioned at the garment label.
This function provides extra amount of steam to remove wrinkles on
delicate garments in hanging position, hanging curtains, or other hanging
fabrics.
Warning:
Do not apply steam on any clothes or fabrics that are being worn by
human or pets. Temperature of steam is very high.
Fill the water tank with demineralised water, or distilled water. (See
–
How To Fill Water)”.
Turn the
–
Temperature Dial (2) in clockwise direction to ●●● position.
Connect the iron to a suitable mains supply outlet. See the item
–
„Preparation for operation“.
Control light (4)
–
glows, indicating that the iron is on.
Control light goes off when the required temperature is reached. The
–
iron is now ready for use.
Move the
–
Steam Control Knob (7) to position.
Hold the iron between 15 and 30 centimetres away from the garment.
–
Press the Burst of Steam Button
–
(9) once – steam will shoot from the
holes of the soleplate.
For stubborn wrinkles, wait a few seconds before pressing the Burst
–
of Steam Button
(9) again. Most wrinkles can be removed within three
presses.
After finishing move the
–
Temperature
Dial (2) in anti-clockwise direction to
„
MIN”; the iron is switched off.
Move the
–
Steam Control Knob (7) to
position.
Disconnect the iron from mains supply
–
outlet.
When the iron gets cool completely, store
–
it vertically in a safe place.
It may be necessary to press the burst of steam button a few times
to start this function.
For optimum steam quality, do not operate the Burst Of Steam more
than three times after the pilot light goes off.