ZELMER 28Z014 - Инструкция (Страница 62)

62 GW28-018_v01
Connect the iron to a suitable mains supply outlet with grounding– you –
will hear a sound signal.
The buttons
– , , , Soft, medium or hard water indicator (depend-
ing on setting), indicator, indicator shall glow for a moment and
go off. Press to turn on the appliance.
After a while you will hear the sound again and the – high steam level
button (19) shall glow and go off when the required temperature of the
base is reached.
Switch off steam ironing by pressing – steam ironing button (13), the
button light shall go off.
The high steam level button (19) – shall switch off parallel.
Turn the – Temperature Dial (1) in clockwise direction to; set ●, ●● or ●●●
position.
Control light (4) – goes off when the required temperature is reached.
The iron is now ready for use. –
After operation move the – Temperature Dial (1) in anti-clockwise direc-
tion to „ MIN”; the iron is switched off.
Press the – power button (12) to switch off the appliance.
Disconnect the iron from the mains supply outlet. –
When the iron gets cool completely, drain the water from the tank – (8)
and store in a safe place.
Auto shut-off system
If the steam function is not used over 10minutes, the appliance will go to
“sleep” mode. The power button (12) will go off. When you press Power
button (12) or Burst of steam button (3), the appliance shall switch on
immediately.
Steam ironing – Always follow the garment manufacturer’s ironing
instructions mentioned at the garment label.
After each button pressing the appliance makes „beep” sound. –
Unwind and straighten the power cord. –
Fill the iron as described in “How to fill water” –
Connect the iron to a suitable mains supply outlet with grounding– you –
will hear a sound signal.
The buttons
– , , , Soft, medium or hard water indicator (depend-
ing on setting), indicator, indicator shall glow for a moment and
go off. Press to turn on the appliance.
After a while you will hear the sound again and the – high steam level
button (19) shall glow and go off when the required temperature of the
base is reached.
In the same time the soft, medium or hard water indicator shall glow –
(depending on setting).
Press – low (17)/medium (18)/ high steam level button (19), to select
steam level.
Turn the – Temperature Dial (1) in clockwise direction to; set ●, ●● or ●●●
position.
Control light (4) – goes off when the required temperature is reached.
The iron is now ready for use. –
After operation move the – Temperature Dial (1) in anti-clockwise direc-
tion to „ MIN”; the iron is switched off.
Press the – power button (12) to switch off the appliance.
Disconnect the iron from the mains supply outlet. –
When the iron gets cool completely, drain the water from the – tank (8)
and store in a safe place.
ATTENTION:
If you press the burst of steam button (3) when the generator has not
reached desired temperature you will hear a „beep” sound. To start
up burst of steam function it can be necessary to press (3) several
times.
Burst of steam in vertical position – Always follow the garment
manufacturer’s ironing instructions mentioned at the garment label.
This function provides extra amount of steam to remove wrinkles on delicate
garments in hanging position, hanging curtains, or other hanging fabrics.
Fill the iron as described in “How to fill water”. –
Turn the – Temperature Dial (1) in clockwise direction to ●●● position.
Connect the iron to a suitable mains supply outlet with grounding (See –
„Preparation for operation“).
Control light (4) – glows. Control light (4) goes off when the required
temperature is reached.
Hold the iron 10 cm away from the garment. –