Инструкция по эксплуатации ZELMER 28Z014
Страница 60
60
GW28-018_v01
C. Control panel
11. Water level indicator
12. Power button indicator
a) Light – Power on
b) No light – Power off
13. Steam ironing button
a) No light – Dry ironing
b) Light – Steam ironing
14. Water hardness button
a) Soft water indicator
b) Medium water indicator
c) Hard water indicator
15. Change anti-calc cartridge indicator
16. Water tank disconnection button
17. Low steam level button
18. Medium steam level button
19. High steam level button
(14), to select water hardness level HI (high), MI (medium) or LO (low),
which you can adjust until the button blinks.
Wait about 10 seconds, to save the settings.
–
Water hardness level shall be adjusted.
How to fill the water
The appliance has an electronic system
monitoring the water level.If the water level
is lower than the pre-set value, the
Water
level indicator (11) will glow and emit
sound until
water tank (8) is re-filled.
While Steam Ironing, When the water level
gets lower than the pre-set value,
Water
level indicator (11) will flash until water
tank (8) is re-filled.
Press the
–
Water tank disconnection
button (16).
Sidle out and remove
–
water tank (8).
Operation with heat insulation board
The Heat insulation board can be taken to anywhere, so that you are more
convenient on ironing
1. Remove the
Heat insulation board (7) from the Base unit (6)
2. Take the
Heat insulation board (7) to desired place
Water hardness checking
Unpack attached water hardness tester.
–
Put the strip under running water for 1 second.
–
Shake the paper to remove water.
–
Wait 15 seconds.
–
Check the strip colour with water hardness indicator.
–
Adjust your steam generator to the water hardness.
–
Water hardness setting
Check the water hardness according to „Water hardness checking”.
–
Press and hold the water
–
hardness button (14) for 3 seconds.
When you hear sound signal press the water hardness button again
–