Maintenance, English 41 settings & references, How to clean the connectors – Инструкция по эксплуатации JVC KD-BT1

Страница 41: Moisture condensation, How to handle discs

Advertising
background image

ENGLISH

41

SETTINGS & REFERENCES

Setting menu

( : Initial)

Auto Connect

When the unit is turned on, the connection is
established automatically with....
Off:

No Bluetooth device.

Last:

The last connected Bluetooth device.

Order:

The available registered Bluetooth device
found at first.

Auto Answer

Only for the device being connected for “Bluetooth
Phone.”
Off:

The unit does not answer the calls
automatically. Answer the calls manually.

On:

The unit answers the incoming calls
automatically.

Reject: The unit rejects all incoming calls.

Message Info

Only for the device being connected for “Bluetooth
Phone.”
Auto:

The unit informs you of the arrival of a
message by ringing and displaying “MSG.”

Manual: The unit does not inform you of the arrival of

a message.

MIC setting

Only for the device being connected for “Bluetooth
Phone.”
Adjust the microphone volume, [Level 01/02/03].

Version

The Bluetooth software and hardware versions are
shown.

Maintenance

How to clean the connectors

Frequent detachment will deteriorate the connectors.
To minimize this possibility, periodically wipe the
connectors with a cotton swab or cloth moistened with
alcohol, being careful not to damage the connectors.

Moisture condensation

Moisture may condense on the lens inside the unit in
the following cases:
• After starting the heater in the car.
• If it becomes very humid inside the car.
Should this occur, the unit may malfunction. In this
case, eject the disc and leave the unit turned on for a
few hours until the moisture evaporates.

How to handle discs

When removing a disc from its
case,
press down the center holder
of the case and lift the disc out,
holding it by the edges.
• Always hold the disc by the edges.

Do not touch its recording surface.

When storing a disc into its case, gently insert the
disc around the center holder (with the printed surface
facing up).
• Make sure to store discs into the cases after use.

Center holder

Connector

Continued on the next page

EN34-43_KD-BT1_001A_2.indd 41

EN34-43_KD-BT1_001A_2.indd 41

2/12/07 12:25:19 PM

2/12/07 12:25:19 PM

Advertising