Selecting the wash program, When the program has finished – Инструкция по эксплуатации Candy HOLIDAY 084DF

Страница 58

Advertising
background image

58

Putting detergent in machine
D) Open the drawer, choose the detergent and put in
the correct amount, according to the manufacturer’s
instructions and the advice on page "Detergents, wash-
ing aids and amounts to use".
E) Add any other laundry aids.
F) Close the drawer again.
Liquid detergents that are to be placed directly into the
drum should use the recommended dispensing device.

Selecting the wash program


Refer to the program guide to select the most suitable program.

Turning the selector knob required program is activate.
The display will show the settings for the programme selected.
Then press the “START/PAUSE” button.
When the “START/PAUSE” button is pressed the machine sets
the working sequence in motion.
The program carries out with the program selector stationary
on the selected program till cycle ends.

WARNING!
If there is any break in the power supply while the machine is operating, a special
memory stores the selected program and, when the power is restored, it contin-
ues where it left off.

When the program has finished

-

The display will read “END”.

-

Wait for the door lock to be released (about 2 minutes after the program has finished).

-

Switch off the machine by turning the program selector to the “OFF” position.

-

Open the door and remove the laundry.

Disconnect the plug from the mains power supply and turn off the water supply after every
use.

For all types of wash consult the program table and follow the operations in the or-
der indicated.

Advertising
Эта инструкция подходит к следующим моделям: