Candy HOLIDAY 084DF - Инструкция (Страница 45)

45
Water supply
The machine has an inlet hose with ¾" threaded ferrules
fitted to the ends to attach between the threaded connec-
tor on the appliance and the cold water supply.
The appliance must be connected to the water mains us-
ing new hose-sets. The old hose-sets should not be re-
used.
The appliance must only be connected to the cold water
supply.
Connection to a warm water supply, that is over 40°, may
damage certain delicate fabrics.
Note: it is advisable to turn off the tap after each
wash to isolate the washing machine from the water
supply.
Position the washing machine next to the wall. Hook the
outlet tube to the edge of the bath tub, paying attention
that there are no bends or contractions along the tube.
If the inlet hose’s connection point is changed, check that
the ¾" threaded ferrule on the inlet hose is firmly attached
to the electrovalve connector.
For the washing machine to function properly the terminal end of the discharge
hose (mouth) must be at a minimum of 50 cm and a maximum of 85 cm from the
ground.