Candy HOLIDAY 084DF - Инструкция (Страница 49)

49
"Start delay" button
F
This button allows you to preprogram the wash cycle to delay the start of the cycle
for up to 24 hours.
To delay the start use the following procedure:
 Set the required program;
 Press the button once to activate it (h00 appears on the display) and then press it again
to set a 1 hour delay (h01 appears on the display). The pre-set delay increases by 1 hour
each time the button is pressed, until h24 appears on the display, at which point pressing
the button again will reset the delay start to zero.
Confirm by pressing the “START/PAUSE” button (the light on the display starts to flash).
The countdown will begin and when it has finished the program will start automatically.
It is possible to cancel the delay start by taking the following action:
 Press and hold the button for 5 seconds until the display will show the settings for the
program selected.
At this stage it is possible to start the program previously selected by pressing the
“START/PAUSE” button or to cancel the process by setting the selector to the OFF posi-
tion and then selecting another program.
"Spin speed" button
G
The spin cycle is very important to remove as much water as possible from the laundry
without damaging the fabrics. You can adjust the spin speed of the machine to suit your
needs.
By pressing this button, it is possible to reduce the maximum speed, and if you wish, the
spin cycle can be cancelled.
To reactivate the spin cycle is enough to press the button until you reach the spin speed
you would like to set.
For not damage the fabrics, it is not possible to increase the speed over that
automatically suitable during the selection of the program.
It is possible to modify the spin speed in any moment, also without to pause the ma-
chine.
NOTE: The machine is fitted with a special electronic device, which prevents the
spin cycle should the load be unbalanced. This reduces the noise and vibration in
the machine and so prolongs the life of your machine.