Candy GO4 107 2D - Инструкция (Страница 64)

64
Putting detergent in machine
D) Open the drawer, choose the detergent and put in the
correct amount, according to the manufacturer’s instructions
and the advice on page "Detergents, washing aids and
amounts to use".
E) Add any other laundry aids.
F) Close the drawer again.
Liquid detergents that are to be placed directly into the drum
should use the recommended dispensing device.
Selecting the wash program
Refer to the program guide to select the most suitable pro-
gram.
The program is selected by turning the program selector
clockwise and aligning the program number with the indicator.
The display will show the settings for the programme selected.
Check that the tap is turned on and that the discharge hose is
positioned correctly.
Adjust the wash temperature if necessary.
Press additional function buttons if you require.
Press the start button, the program will begin.
When the START button is pressed the machine sets the working sequence in motion.
The program carries out with the program selector stationary on the selected program till
cycle ends.
WARNING!
If there is any break in the power supply while the machine is operating, a special
memory stores the selected program and, when the power is restored, it contin-
ues where it left off.
When the program has finished
– The display will read “END”.
– Wait for the door lock to be released (about 2 minutes after the program has finished).
– Switch off the machine by turning the program selector to the “OFF” position.
– Open the door and remove the laundry.
Disconnect the plug from the mains power supply and turn off the water supply after every
use.
For all types of wash consult the program table and follow the operations in the or-
der indicated.