Kenwood ST532 - Инструкция (Страница 4)

goes out pull the material slightly
with one hand; hold the iron upright
with the other.
6 Tilt the iron forwards, then move it
downwards approximately 10-15cm
away from the material, repeatedly
pressing the shot of steam button.
● Do not press the shot of steam
button more than three times in
succession if the temperature light is
on.
● Never steam clothes being worn.
Keep your hands away from the
steam and soleplate.
auto safe ST540 series only
For safety reasons, your iron will
automatically stop heating if it’s left:
● upright for eight minutes or
● flat for 30 seconds or
● accidentally tipped on its side or
knocked off the ironing board.
The red auto safe light will flash and
there will be an audible bleep. The
iron will heat up again when you
move it, the auto safe light will go
out, and the bleeping will stop.
after ironing
1 Turn the temperature control to 'min'
and the variable steam control to .
2 Unplug and allow the iron to cool.
3 Hold the iron with the point facing
downwards and press the water fill
inlet cover.
4 Turn the iron so that the point is
facing uppermost and allow the
water to drain out.
5 Once the iron is empty press the
water inlet fill cover to close.
important Failure to allow the iron
to cool, or pressing the water inlet fill
cover with the point of the iron
facing uppermost when emptying,
may result in burns.
6 Loosely wrap the cord around the
iron
ᕣ
6 Store the iron upright.
care and cleaning
● Always unplug before cleaning.
● Never use abrasives.
● Never put anything other than water
into the water tank.
the inside - self clean
To make your iron last longer, do this
at least once a month.
1 Fill the water tank a quarter full with
water.
2 Place the iron on a surface in an
upright position and plug into the
power supply. Make sure the
variable steam control is set
to .
3 Turn the temperature control to the
maximum setting.
4 Wait for the iron to reach the
selected temperature. Then wait for
one more cycle ie wait for the red
light to come on and go off again.
5 Turn the temperature control to the
minimum setting.
6 Disconnect the iron from the power
supply and hold in a horizontal
position over a sink.
7 Turn the variable steam control to
and hold in place. Steam and
boiling water will drain from the holes
in the soleplate washing away the
scale and minerals that have built up
inside the steam chamber.
8 Gently move the iron back and
forward until the water tank is empty.
9 When self cleaning is complete,
release the variable steam control.
10 Rest the iron on its heel and allow to
cool.
11 Wipe the soleplate with a damp
cloth, then dry.
● Before the next use, iron an old cloth
to make sure the soleplate and
water tank are clean.
4