Kenwood ST532 - Инструкция (Страница 2)

before using your Kenwood
appliance
● Read these instructions carefully and
retain for future reference.
● Remove all packaging and any
labels.
● Test-iron an old cloth to make sure
the soleplate and water tank are
clean.
safety
● Never bend the cord guard when
wrapping the cord around the iron -
in time the cord will burn out.
● Don't get burnt by the iron's steam,
hot water or soleplate.
● Steam or hot water can come out of
the soleplate when you're not
expecting it, such as when you raise
the iron from flat to upright. So make
sure no one's in the way.
● Keep children away from the iron.
And make sure they can't grab the
cord and pull the iron down.
● Never iron clothes being worn.
● Never put the iron, cord or plug in
liquid - you could get an electric
shock.
● Never use a damaged iron. Get it
checked or repaired: see 'service
and customer care'.
● Never leave the iron on unattended.
● Unplug:
● ● before filling with water or
emptying water out
● ● before cleaning
● ● straight after use
● Only use the jug provided to fill the
tank, never put the iron under the
tap to fill.
● After filling with water, make sure the
water fill cover is fully closed.
● Always allow the iron to cool before
emptying any water from the tank.
● During ironing pauses, never leave
the iron flat - it could burn what's
underneath. Leave it upright.
● Do not let infirm people use the
appliance without supervision.
● Do not let children use or play with
the appliance.
● Only use the appliance for its
intended domestic use. Kenwood
will not accept any liability if the
appliance is subject to improper use,
or failure to comply with these
instructions.
before plugging in
● Make sure your electricity supply is
the same as the one shown on the
heel of your iron.
● This iron complies with European
Economic Community Directive
89/336/EEC.
know your Kenwood
iron
ቢ variable steam/self clean control
ባ shot of steam button
ቤ spray button
ብ auto safe light (ST540 series only)
ቦ temperature indicator light
ቧ temperature control
ቨ cord guard
ቩ water fill inlet cover
ቪ heel
ቫ temperature aligning mark
ቭ jug
using your iron
filling with water
1 Unplug.
2 Move the variable steam control to
3 Hold the iron with its point facing
downwards. Press the water fill inlet
cover which will move inside the
iron. Fill the tank with tap water
using the jug provided
ᕡ. Never fill
above the maximum level marked.
4 Press the cover again and it will
return to its closed position.
● If your tap water's hard, use filtered
water - it'll increase the life of your
iron. (Kenwood water filters are
widely available). Don't use distilled
water.
2
ቩ
ቪ
ቭ
ᕢ
ᕣ
ᕡ
ቨ
ma
x
m
in
ቢ
ብ
ቦ
ቫ
ቧ ቤ
ባ
✘
✓