Kenwood ST532 - Инструкция (Страница 3)

● After ironing, unplug and allow the
iron to cool. Press the water fill inlet
cover and turn the iron on its heel
and allow the water to drain out.
choosing the right
temperature
Follow the clothes label advice.
Match the dots on the label to the
dots on the temperature control
ᕢ.
If there's no label, here's a guide on
which temperature to choose:
linen
max
cotton ●●●
wool, silk ●●
synthetics (eg acrylic, nylon,
polyester, viscose)
●
hints
● Start with clothes needing the lowest
temperature, then work upwards.
(This lowers the risk of burning
something because an iron switched
from 'hot' to 'cool' takes time to
cool down.)
● For mixed fibres, eg cotton ●●● and
polyester ● , use the lowest suitable
temperature ● .
● If in doubt, start with a low
temperature on a part that won't be
seen (eg a shirt tail).
setting the temperature
1 Stand the iron upright.
2 Plug into the power supply and the
green temperature indicator light will
glow.
3 Select the desired temperature by
aligning the mark on the body of the
iron with the temperature control.
When the iron reaches this
temperature, the light will go out.
(During ironing, this light will go on
and off as your iron maintains the
right temperature.)
spraying
1 Ensure the variable steam control is
set to , then fill with water.
2 Press the spray button.
● It may be necessary to press the
spray button a few times to start this
function.
steam ironing
1 Ensure the variable steam control is
set to , then fill with water.
2 Plug into the power supply.
3 Turn the temperature control to
●●●
or higher
ᕢ.
4 When the green temperature light
goes out move the variable steam
control to the position required.
Moving the control in an anti-
clockwise direction will give
maximum steam
. No steam will
be produced on .
All Models are fitted with an anti-drip
system which will automatically stop
the iron from steaming if variable
steam is selected and the
temperature is too low. During use
the anti drip system may emit a loud
clicking noise, particularly during
heat up or whilst cooling down. This
is normal and indicates that the
system is functioning correctly.
5 Steaming can be stopped by moving
the variable steam control to .
dry ironing
1 Set the variable steam control to
.
2 Set the temperature control
ᕢ.
shot of steam (during dry or
steam ironing)
If there's water in the iron and the
temperature's on
●●● or higher, just
press the shot of steam button.
● When using shot of steam, water
may leak from the iron if the
temperature is too low.
steaming the creases out of
curtains, hanging clothes,
wall hangings
1 Move the variable steam control to
.
2 Fill with water.
3 Plug into the power supply.
4 Turn the temperature control to
●●●
or higher
ᕢ.
5 When the green temperature light
3