Hyundai H-CMMD4043 - Инструкция (Страница 21)

Aspect ratio
• Press DISP / WIDE button on the monitor or WIDE on the Remote Control repeatedly to select the aspect
ratio: FULL => NORMAL => STANDBY => NORMAL => FULL.
Image setting
1. Press the PIC button on the RC on the monitor to enter the picture quality setting menu.
2. Press the M / ^buttons on the RC or the A/T button on the panel to select the setting.
3. Press the ^/^ button on the RC or the ◄/► button on the panel to adjust the setting.
4. Press the PIC button on the RC to exit.
Parking cable function
If the PRK SW cable is connected to hand brake switch, the video view to the
TFT monitor will be switched between Normal display and Caution display.
Parking cable function is ceases if Parking is OFF. Please refer to PARKING.
When Parking is ON the monitor will show the special screen to prevent the
driver watching other content during driving. The passengers at the rear can watch
normally.
Monitor movement mechanism
When any path blocking or obstruction for the movement of the monitor occurs,
the following protection executes to prevent any damage to the loader or the
monitor. After the protection executed normal operating resumed after the
following action of the monitor performed by pressing the OPEN/CLOSE button
or repowering the unit. If it doesn’t help please reset the unit.
ATTENTION
DO NOT USETHISFUNCTION
WHILE DRIVING!
O bstruction /
Blocking
Situation
Self
protection
of this unit
After O PEN
key is
pressed
Disconnect &
reconnect
the pow er
M onitor
loading out
horizontally
Auto loading
back in to the
m echanism
Fully
extended
horizontally
Auto loading
back in to the
m echanism
M onitor
loading in
horizontally
Slop at the
obstruction
point
Fully
extended
horizontally
Loading back
in to the unit
M onitor
loading out
vertically
Slop at the
obstruction
point
Sw iveling
back to
the unit
Sw iveling
back to
the unit
M onitor
loading
in vertically
Stop at the
obstruction
point
Sw iveling
ba ck to
the unit
Sw iveling
back to
the unit
21