Product description, For the qualified engineer, Preparation for installation – Инструкция по эксплуатации Bosch Tronic 2000
Страница 14: Wall mounting
Внимание! Текст в этом документе был распознан автоматически. Для просмотра оригинальной страницы Вы можете воспользоваться режимом "Оригинал".
Product description
This instruction manual describes various appliance models.
General
• The hydraulically controlled flow-through water heater is suitable tor either an open
(depressurised) or closed (pressurised) connection.
• The flow-through water heater continuously heats water while it flows through the appliance.
• The appliance must not be operated with preheated water, otherwise the overtemperature
protection will be triggered.
• These appliances are designed for permanent electrical connection.
ED6-2S
high level appliance
ED5-S/U
under counter appliances
For the qualified engineer
Preparation for installation
For all appliances
• There must be a clearance of approximately 60 mm on all sides of the appliance for installation.
• Observe the technical data for the appliance
•
Flush the cold-water supply line and shut it off.
•
Unscrew the screws on the housing cover and remove the lid.
Wall mounting
For all appliances
• Secure the appliance using the installation template, screws and wall plugs so that it is vertical
and flush against the wall.
1. Locate the appliance on the screw and press down.
2. Screw in the second screw through the mounting tab and tighten.
•
For an exposed electrical connection, the different methods of routing the supply line found on
the assembly template must be observed.
• The cable bushing must firmly enclose the connecting cable to ensure that it is protected
against moisture. In the event of damage, seal the opening so that it is watertight.
14