Mongoose EMS 1.9R - Инструкция (Страница 31)

Two Way Car Alarm System MONGOOSE EMS 1.9R 31
ENGLISH
Valet Mode
When the system is disarmed and the ignition is switched on, press buttons 1 and 2 together
for over 3 seconds, the parking lights will flash 3 times. This will mean that the alarm system is
off (Valet mode) but the central door locking and auxiliary outputs will continue to function as
normal. The LED staying on constantly indicates valet mode.
If both buttons are pressed again with the ignition on the alarm system will return to normal
operation and this will be indicated by three beeps from the siren.
Valet mode can be used while servicing or repairing your car by maintenance staff.
The Valet mode indicator will appear on the LCD screen to indicate the alarm
system is off.
System Programming
Remote Code Learning
The EMS 1.9R has one two way Transceiver and one one way transmitter in the standard
kit, however the system can teach up to eight transmitters/transceivers. To increase a number
of remote controls to control the alarm system fulfill the below procedure:
The basic procedure is the same regardless of single digit pin code or two digit pin code. If the
system has a single digit PIN code, follow steps 1 2 but skip steps 3 4. If the system has a two digit
PIN code follow the entire procedure.
b. When the alarm system is disarmed turn the ignition on.
c. Press the override switch as many times as the first digit of the PIN code.
d. Cycle the ignition off/on.
e. Press the override switch as many times as the second digit of the PIN code.
f. Switch the ignition off. If the PIN code is correct one short and one long beep will
confirm entering the Code Learning.
g. Switch the ignition on.
h. Press button 1 of each remote control you want to program to the system. One siren beep
will confirm the transmitter code is learnt. When you are programming a two way
transmitter please wait a few seconds after the beep until the indicator icon on the LCD
screen is flashing two times to confirm the main unit code has been programmed to the
transceiver, otherwise the pager function will not work.
i. To exit the Code Learning switch the ignition off and press the override switch or wait for
15 seconds, a double siren beep will confirm that Code Learning has exited. NOTE: If
you want to move to the Function Programming switch the ignition back on without
pressing the override switch and before the double siren beep.
Руководство пользователя
EMS 1.9R
38
Символы ЖКИ дисплея
Индикатор часов
Замки дверей заперты
Замки дверей открыты
Включен режим
энергосбережения
Двигатель заведен (Охрана с
заведенным двигателем)
Открыта дверь
Включено зажигание
Передача команды
Valet режим
Тестовый режим
Включена функция
блокировки кнопок пульта
Таймер парковки