Ems 1.9r, Auxiliary outputs, Таблица команд пульта управления. (продолжение) – Инструкция по эксплуатации Mongoose EMS 1.9R

Страница 24

Advertising
background image

User’s Guide

EMS 1.9R

24

the system will transmit a test signal to the Hand Held Transceiver to test the range of the pager
system. The pager test indication will last for 2 minutes. You can cancel the Pager Test indication
before 2 minute period is over by pressing any button of the Handset. This Pager Test will be
available as many times as you press button 3 within the armed period (one activation for each
pressing).

When the transceiver receives a test signal the Pager Test icon will be displayed on

the LCD panel, the pager test melody will be sounding, and all symbols will be
displayed on the LCD panel one after another.

Auxiliary Outputs

Trunk Release Output

Pressing button 2 for 3 seconds activates the Trunk Release output. This will issue an impulse

on the trunk release output wire and will override the sensors and trunk input until 10 seconds
after the trunk switch is closed.

Comfort/Two Stage Unlock Output

If you set the programming for the Comfort Window Close option, the Output will be

automatically activated when the alarm system is armed either by remote control or by key or by
passive arming (not re arming) it remains active for 20 seconds. During the 20 second close
period and for the first 10 seconds after the comfort close period, the two sensor sockets will be
disabled. This is to ensure that the sensors cannot trigger the alarm system during the comfort
close period and to allow a 10 second settling period after the close period for the sensors to
settle.

If set the Two Stage Unlock will operate as describe in sections “Disarming” and “Ignition

Safety Door Lock/Unlock”.

Latch Output//Brake/Clutch Output

Depending on program setting the output will operate in two different modes:

1. Latch Output the output will be activated as soon as button 1 and 2 are pressed at the

same time and will be turned off by the second simultaneous press of buttons 1 and 2.

2. Brake/Clutch Output – the output is activated as soon as the system receives or generates

a remote starting command and will remain active until the system detects the engine
is started up. This is for the vehicles requiring the brake or clutch pedal to be depressed to
allow running of the starter motor.

Автомобильная охранная система “MONGOOSE” Модель EMS 1.9R

45

РУССКИЙ

Светодиодная индикация состояний системы.

Охрана включена

равномерные короткие вспышки

Включен пассивный иммобилайзер

равномерные длинные вспышки

Включен Anti Hi jack

равномерные короткие вспышки

Предупредительный режим Anti Hi jack

быстро мигает

Охрана отключена

не горит

Автопостановка/перепостановка

быстро мигает

Valet режим

горит постоянно

Заблокирован ввод PIN кода

двойные вспышки

Функция

Кнопка Кнопка

Кнопка Кнопка Кнопка

Примечание

1

2

3

M

S

Включение режима ежедневного запуска двигателя

2

1

Зажигание ВЫКЛ.

в заданное время

Синхронизация часов
выполнена.

Дистанционное глушение двигателя

2

1

Двигатель работает
под управлением
охранной системы.

Дополнительные функции двунаправленного пульта управления

Режим энергосбережения, отключение функции
пейджера
Блокировка кнопок пульта
Включение подсветки дисплея, проверка таймера
парковки
Отключение/включение звукового сигнала
Отключение/включение виброзвонка
Проверка состояния системы и текущего времени
на часах центрального блока
Вход в режим установки часов

3сек

3сек

Вход в режим установки времени ежедневного запуска
Синхронизация часов центрального блока с часами

3сек

3сек

пульта управления
Отключение пассивного иммобилайзера

Номера кнопок задаются

Зажигание ВКЛ.

программированием

Таблица команд пульта управления. (продолжение)

кратковременно нажать один раз
кратковременно нажать два раза в интервале не более 3 секунд

3 сек.

нажать и удерживать кнопку в нажатом состоянии не менее 3 секунд

1 2

последовательность нажатия кнопок

Advertising