Mongoose Cyborg - Инструкция (Страница 7)

Installation Manual
CYBORG
2
System Programming
Remote Code Learning
The Mongoose CYBORG has one two way Transceiver and one one way transmitter in the
standard kit, however the system can teach up to eight transmitters/transceivers. To increase a
number of remote controls to control the alarm system fulfill the below procedure:
The basic procedure is the same regardless of single digit pin code or two digit pin code. If the
system has a single digit PIN code, follow steps 1 2 but skip steps 3 4. If the system has a two digit
PIN code follow the entire procedure.
1. When the alarm system is disarmed turn the ignition on.
2. Press the override switch as many times as the first digit of the PIN code.
3. Cycle the ignition off/on.
4. Press the override switch as many times as the second digit of the PIN code.
5. Switch the ignition off. If the PIN code is correct one short and one long beep will confirm
entering the Code Learning.
6. Switch the ignition on.
7. Press button 1 of each remote control you want to program to the system. One siren beep
will confirm the transmitter code is learnt. When you are programming a two way transmitter
please wait a few seconds after the beep until the indicator icon on the LCD screen is
flashing two times to confirm the main unit code has been programmed to the transceiver,
otherwise the pager function will not work.
8. To exit the Code Learning switch the ignition off and press the override switch or wait for
15 seconds, a double siren beep will confirm that Code Learning has exited. NOTE: If you
want to move to the Function Programming switch the ignition back on without pressing
the override switch and before the double siren beep.
Function programming.
1. Follow through with transmitter programming and turn the ignition back on (do not press
the override switch in the above item 8!).
2. Press the override switch 4 times
3. Cycle the ignition off/on.
4. Press the override switch 6 times.
5. Press buttons 1 and 2 together. An audible signal will confirm the system has entered the
Installer’s Function Programming.
6. Turn the ignition off/on.
7. Press the override switch as many times as the number of the software switches group (first
digit).
8. Turn the ignition off/on.
9. Press the override switch as many times as the number of switch within the group (second
digit).
Автомобильная охранная система “MONGOOSE” Модель CYBORG 15
РУССКИЙ
СХЕМА ПОДКЛЮЧЕНИЙ