Petsafe Stubborn Dog In-Ground Fence™ System - Инструкция (Страница 154)

TROuBlesHOOTiNG
Receiver Collar is not beeping
or delivering stimulation.
•Check battery to make sure it is installed properly.
•Check that both lights are lit on the Fence Transmitter. If not, perform the “Short Loop Test”.
The Receiver Collar is beeping,
but the pet is not responding to
the static stimulation.
•Make sure the Static Stimulation Level is set to level 2, 3, 4 or 5.
•Test the Receiver Collar with the Test Light Tool while walking toward the Boundary Wire.
•If the Test Light flashes, check the fit of the Receiver Collar.
•Trim your pet’s fur where the Contact Points touch the neck and/or use the longer Contact Points
included in the system.
•Increase the Static Stimulation Level.
•Repeat training steps to reinforce training.
The Receiver Collar has to be
held on top of the Boundary
Wire to activate.
•Replace battery.
•Adjust Boundary Width Control knob clockwise to increase the distance from the Boundary
Wire that the Receiver Collar activates. You can also adjust the Boundary Control Switch to
another setting.
•If using a Double Loop, make sure Boundary Wires are separated 1.5 m.
•If the Receiver Collar still has to be held on top of the Boundary Wire, perform the
“Short Loop Test”.
The Receiver Collar activates
inside the house.
•Turn the Boundary Width Control knob counterclockwise to decrease the distance from the
Boundary Wire that the Receiver Collar activates.
•Make sure the Boundary Wire is not running too close to the house. The signal can transmit
through the walls of your house.
•Make sure Boundary Wires are twisted from Boundary to the Fence Transmitter.
i have an inconsistent signal. •Make sure Fence Transmitter is at least 1 m from large metal objects or appliances.
•Make sure all Boundary Wire turns are gradual (minimum 1 m radius).
•Make sure the Boundary Wire is not running parallel to and within 1.5 m of electrical
wires, neighbouring containment systems, telephone wires, television or antenna cables, or
satellite dishes.
•If a neighbouring containment system may be causing an inconsistent signal, contact the
Customer Care Centre to see if a different frequency system will help your situation.
The Power and loop indicator
lights are off.
•Check that the Power Adapter is plugged into the Fence Transmitter.
•Try plugging into another standard outlet.
•If the lights still do not come on, the Fence Transmitter and/or the Power Adapter needs to be
replaced. Contact the Customer Care Centre.
The Power light is on, the loop
indicator light is off, and the
Fence Transmitter loop alarm
is sounding.
•Make sure both ends of the Boundary Wire are plugged into Boundary Wire Terminals and that
1 cm of the insulation is stripped so that the copper wire is exposed.
•Make sure the Boundary Wire is not cut off or pinched by a window, door, or garage door.
•Perform the “Short Loop Test” to determine if the Fence Transmitter needs to be replaced or if the
Boundary Wire is broken.
•If the Fence Transmitter is functioning properly, you have a break in your Boundary Wire. See
the “To Locate a Break in the Boundary Wire” section in this guide.
154 www.petsafe.net
FI
DA
SV
RU
NO
EN