Обязательные уведомления, Fcc statement (usa), Заявление о светодиодном индикаторе – Инструкция по эксплуатации HP Принтер HP Deskjet 710c

Страница 69: Заявление о блоке питания

Внимание! Текст в этом документе был распознан автоматически. Для просмотра оригинальной страницы Вы можете воспользоваться режимом "Оригинал".

Advertising
background image

Обязательные уведомления

FCC statement (USA)

The United States Federal Communications Commission (in 47 CFR 15.105) has specified that the following notice be

brought to the attention of users of this product:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of

the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try

to correct the interference’s by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Use of a shielded cable is required to comply within Class B limits of Part 15 of FCC Rules.
Pursuant to Part 15.21 of the FCC Rules, any changes or modifications to this equipment not expressly approved by
Hewlett-Packard Company may cause harmful interference and void the FCC authorization to operate this equipment.

Заявление о светодиодном индикаторе

Светодиодные индикаторы дисплея соответствуют требованиям стандарта Е1 60825-1.

Заявление о блоке питания

Блок питания ремонту не подлежит. При выходе из строя его следует выбросить или вернуть поставщику.

63)

Advertising