LG V-C446*** - Инструкция (Страница 4)

Information for your safety
Please read all the following information,
which contains important instructions for the
safety, the use and the maintenance of the
appliance.
This appliance complies with the following EC
Directives: -73/23/EEC, 93/68/EEC-Low
Voltage Directive-89/336EEC -EMC Directive.
■ Never allow children to use the appliance
unsupervised.
■ Do not use the appliance If the mains lead is
damaged or faulty.
■ If the mains lead is damaged, it must be
replaced by an approved LG Electronics
Service Agent as special tools are needed
to repair it.
■ Always switch the vacuum cleaner off before :
* changing the dust bag
* changing or cleaning the filters.
■ If no dustbag is inserted, the cover cannot
be closed. Please do not use force!
■ Do not vacuum flammable or explosive
substances(liquids or gases).
■ Do not vacuum hot ash, embers etc. nor
sharp objects.
■ Do not vacuum water or other liquids.
■ Please make sure when using the carrying
starp that it is securely fitted.
■ When you vacuum with an attachment
appliance that has a rotating brush roller:
* do not reach into the running brush roller.
■ Do not vacuum fine dust.
■ Do not expose vacuum cleaner to heat.
Important for users In the UK.
The wires in the mains lead of this appliance
are coloured in accordance with the following
code:
BLUE-neutral BROWN - live
As the colours of the wires in the mains lead of
this appliance may not correspond with the
coloured markings identifying the terminals in
your plug,
PROCEED AS FOLLOWS:
The wire which is coloured BROWN must be
connected to the terminal which is marked L
or coloured RED.
The wire which is coloured BLUE must be
connected to the terminal which is marked N
or coloured
BLACK!
VERY IMPORTANT:
Neither wire is to be connected to the earth
terminal of a 3 pin plug. If a 13 amp plug is
fitted, fit a 13 amp
BS 1362 fuse.
If any other type of plug is used, protect with
a 15 amp fuse at the distribution board.
For appliances which come with mains lead
and plug moulded on : the plug moulded on to
the cord incorporates a fuse.
For replacement use a 13 amp BS 1362 fuse.
Only ASTA approved or certified fuses should
be used.
The fuse cover/carrier must be replaced in the
event of changing the fuse.
The plug must not be used if the fuse
cover/carrier is lost. A replacement cover/
carrier must be obtained from authorised
electrical goods retailers.
WARNING! Should it become necessary to
replace the moulded on plug then the
detective plug should be destroyed to avoid
any possible shock hazard that could occur
should such a plug be inserted into a 13 amp
socket elsewhere in the house.
How to Use
Connecting the flexible hose
Insert the hose holder (1) into the suction
opening.
When the hose (2) is to be disconnected from
the appliance, press the release button (3) and
pull the hose holder out of the suction
opening.
Assembling the tubes
■ Telescopic tube (4)
- Hold spring latch (5)
- Pull out the tube to required length.
- Release spring latch to lock.
Using the cleaning head and
Accessory Nozzles
Fit the large cleaning head onto the end of the tube.
* The 2 position head (6) is equipped with a
pedal (7) which allows you to alter its position
according to the type of floor to be cleaned.
Hard floor position(tiles, parquet floors...),
slide on the lever to lower the brush.
Carpet or rug position, slide on the lever to
lift brush up.
- 4 -