Kastor KSIS Wood-burning sauna stoves - Инструкция (Страница 28)

28 / 54
1. Before you install
Inspect both product and the contents of the package as soon as you receive them. Report any
transport damages to the deliverer.
1.1. Package contents and its inspection
The stove package contains:
•
Stove
•
Within the fire compartment
•
Installation instructions
•
Grate
•
Air guide plate
•
Connection pipe
•
One steel plug (on top of the stove in the foremost sweeping hole).
1.2. Important matters and regulations
During installation and use these instructions and all relevant official regulations must be
followed. The sauna stove must not be used for any other purposes such as drying clothes,
heavy heating during building etc. The stove must also never be covered in any way during use
or when it is warm.
Also check the following aspects and their influence on your choice of stove installation location:
•
Safety distances to flammable and non-flammable structures (Chapter 2.3.
and 2.4.)
•
Location of chimney connection (height from floor of any existing chimney
connection or installation route of any new chimney pipe)
•
Floor material (flammable, non-flammable, tiled and waterproofed)
2. Installation and preparation for use
2.1. Preparing for use and burn-in
•
Place the stove outdoors on a non-flammable surface
•
without stones
•
tank, if any, filled with water
•
Remove any decals and protective plastic sheeting.
•
Check that the grate and air guide plate (see chapter 2.8.) are in place.
•
Install the connection pipe delivered with the package into the door-side flue opening on
top of the sauna stove.
•
Burn-in: The purpose of the burn-in is to remove out of doors any flammable protective
coating substances and to harden the stove’s coating. Burn a few full loads of wood in the
fire compartment. Continue the burn-in until there are no more fumes rising from the
stove.
•
Once the stove has cooled down after the burn-in, move it into the sauna.
•
See to it that the sauna is well ventilated during the first couple of heating.
2.1.1 INSTALLATION THROUGH THE WALL AND FITTING THE FRAME
See also the instructions in chapter 2.6. concerning flue pipe installation.
Installation through the wall:
•
Remove covering frame from the front (if it is there).
•
Loosen the frame's attachment screws (4 screws on both sides, no need to remove
them).