Vitek VT-3476 - Инструкция (Страница 8)

recorded or the environment that it was record-
ed in.
Do not insert a blank CD-R/CD-RW disc.
Reading the disc will take time and removing the
disc while it is still spinning may cause damage
to it.
CDs with the mark "SUPER-AUDIO CDs" are not
playable.
• CDs with an imbedded copy control function
may not be playable.
• DVDs, VCDs (video CDs), photo CDs are not
playable.
• WMA format discs are not playable.
• Do not use heart-shaped, octagonal-shaped or
other irregularly shaped CDs. The device may
malfunction.
• Cracked or deformed discs, or discs repaired
with glue or tape are dangerous and should not
be used.
STORING THE DISC
• Always store a disc in its proper case.
• Store out of direct sunlight and away from any
warm place such as near a heater.
DISC MAINTENANCE
Before playing a disc, remove any dust, dirt or
fingerprints from the play side by wiping from
the center outwards with a soft cloth. o Do not
use thinner, benzene, record cleaning agent or
static electricity suppressing agent when clean-
ing the disc.
Cautions on Condensation
Should the ambient temperature change sud-
denly, condensation (water droplets) may form
on the internal optic lens. You may not be able to
play a disc normally in this condition. If this
occurs, remove the disc, and allow the device to
sit unused for approximately one hour, then try
again.
LISTENING TO CDS
1. Move the FUNCTION switch to CD.
When no disc is loaded [- - -] appears on the
display panel.
If a CD is loaded the number of tracks on the CD
Is displayed.
2. Loading a CD.
• Press the OPEN button to open the CD door.
• Place the CD so the label faces Is up.
• You cannot load more than one CD at a time.
3. Close the CD door. o Press the CD door until
you hear It click shut.
The number of tracks on the CD is displayed.
4. Press the PLAY/PAUSE button ( /II). The CD
plays starting from track 1.
• When the last track is finished the CD automati-
cally stops.
ENGLISH
8
3476.qxd 01.04.2005 22:13 Page 8