Vitek VT-3468 - Инструкция (Страница 5)

ENGLISH
REMOTE CONTROL
POWER SOURCE (SYSTEM WITH 2 POWER SOURCES)
This appliance is designed to be used from two different power sources, which are listed below:
DC POWER SOURCE
This appliance can be powered by 8 type UM2 or C batteries. For best results, always use alkaline bat-
teries.
INSTALLING THE BATTERIES
1. Remove the battery compartment lid by gently pressing on it and pulling it up.
Insert 8 type UM2 or C batteries.
MAKE SURE TO OBSERVE POLARITY (+/-), AS INDICATED ON THE INSIDE OF THE COMPARTMENT.
2. Close the lid.
NOTE: To avoid damage to your appliance, remove the batteries if the appliance will not be used for
a long time or if the batteries have gone dead.
NOTE: If you wish to power the appliance with batteries, unplug the power cord both from the
power outlet and from the rear panel of the appliance.
AC POWER SOURCE
Insert one end of the power cord into power cord jack (33), and the other end into AC outlet.
NOTE: If your appliance is equipped with AC input voltage selector switch, make sure that it is set
on voltage the same as voltage in you local area.
4
38.On/Off button
39.Mute button
40.PBC button
41.P/N button
42. OSD button
43. REPEAT A-B button
44. REPEAT 1/ ALL button
45. PROGRAM button
46.ZOOM button
47. STEP button
48. VOLUME DOWN button
49.PLAY/PAUSE button
50.PREV button
51.Battery compartment lid
52. MODE button
53. Tone down button
54. Tone restore button
55. Tone up button
56.TIME button
57. RETURN/STOP button
58. NEXT button
59.VOLUME UP button
60.SLOW button
61.SOUND button
62.AUDIO button
63.Numeric buttons