Vitek VT-3966 B - Инструкция (Страница 9)

ENGLISH
9
press the REPEAT/MONO-ST button to
improve sound quality, to switch on to the
MONO mode.
ANTENNA
For the best FM reception, completely extend
the FM ANTENNA (2, pic.). The device has a
built-in antenna in order to receive AM signals.
Turn the device left or right in order to achieve
the best signal reception.
PROGRAMMING RADIO STATIONS
You can tune and store 20 stations in each band
FM and MW (AM).
. Select the band and tune to the station,
which you want to program.
2. Press the MEMORY/CLK-ADJ button. The
“MEMORY” indication and the “00” station
indication will be flashing on the LCD display
for 3 seconds.
3. Use the PRESET/FOLDER or
buttons to select the station number from
 to 20, under which you want to store the
radio station.
. Press the MEMORY/CLK-ADJ button again,
to store the settings.
5. Repeat steps  –  for all radio stations,
which you want to store in memory.
Note: you must select the station number
while the MEMORY indication is flashing,
otherwise the station will not be stored in the
memory. If the indication disappears before
you select the number of the station, repeat
steps -.
PROGRAMMED RADIO STATIONS RECALL
To recall the programmed radio stations select
the corresponding frequency band (FM or MW
(AW)) and press the PRESET/FOLDER or
buttons successively to select the desired
radio station.
Note: The preset stations are stored in memory,
while the device is plugged in and the battery is
not low. When the power is off or the battery is
low the preset radio stations will be erased from
memory. You will need to program them again.
CD PLAYBACK
Loading – open the CD compartment lid. Insert
a CD disc and close the CD compartment lid.
Ejecting – after the playback stops open the CD
compartment lid and eject the disc. Put the disc
in the case for storage.
Always close the CD compartment lid in order
to prevent it from getting dust. Always eject a
disc from the CD compartment if it is not being
played back.
. Switch on the cassette recorder by pressing
the POWER button.
2. Select the CD playback mode. To select it
press the FUNCTION button successively
until the “CD” indication appears on the LCD
display.
3. Open the CD compartment. Insert a CD disc
and close the CD compartment. Number of
tracks and total playback time will appear on
the LCD display.
If after a CD disc have been inserted the “NO
DISC” indication appears on the LCD display,
check whether the disc is inserted properly. The
disc should be inserted with the label up.
. To playback the disc from the first track
press the PLAY/PAUSE button.
You can select a track, which will be played
back first. To do it, select a track using the
SKIP TUNING  or  buttons, then press
the PLAY/PAUSE button.
5. To pause the playback, press the PLAY/
PAUSE button again. The “PLAY” indication
and the playback time will be constantly
flashing. To resume to playback mode press
the button once again.
6. To stop the playback, press the STOP
button.
Note: if the CD compartment lid is open, the
“OPEN” indication will appear on the LCD
display.
PROGRAMMED PLAYBACK
You can program playback of tracks (max. 60
tracks) in a desired sequence.
. Switch on the cassette recorder by pressing
3966IM.indd 9 07.07.2008 15:40:50