Panasonic ES-LF71 - Инструкция (Страница 8)


English
Cleaningtheshaver
Use the self‑cleaning recharger in temperatures between 15 °C
and 5 °C.
1 1
Inserttheappliancepluginto
theself‑cleaningrecharger.
2 2
Removetheprotectivecapand
thenattachtheshaver.
3 3
PlugintheACadaptorintoa
householdoutlet.
1
3 2
Remove any soap or water on the shaver if it has been washed
with hand soap or any other detergent.
Turn the shaver off before attaching.
Check that the outer foil is not deformed or damaged when you
are attaching the shaver.
Wipe off any water droplets on the main body rear terminal.
4 4
PresstheSELECTbuttontoselectthecourse.
The “Charge” course starts when attaching the shaver.
Each time you press the SELECT button, the course changes
from “Clean/Dry/Charge” “Dry/Charge” “Charge”.
The courses start approximately 6 seconds after they are
selected.
The course will be aborted if the power is cut off. In this case,
perform the course again from the beginning.
Do not detach the detergent cartridge or the water tank as the
cleaning liquid may spill causing a malfunction.

•
•
•
•
•
•
•
•
•
Course Timerequired(guide)
1 Charge
Charge
0 to 60 min
2 Clean/Dry/
Charge
Clean
10 min
Dry
0 min
(170 min*)
Charge
0 to 60 min
It is not possible to change the course after the
“Clean/Dry/Charge” course has started. •
3 Dry/Charge
Dry
10 min
Charge
0 to 60 min
It is possible to change to the “Clean/Dry/
Charge” course even after the “Dry/Charge”
course has started. •
* When the ambient temperature of the self‑cleaning recharger is
low (approx. 15 °C or lower), the time it takes to dry the shaver
increases.
The Clean or Dry function may stop under extreme low
temperatures (approx. 0 °C or lower). In such a case, the CLEAN
and DRY lamps will blink when the “Clean/Dry/Charge” course is
selected, or the DRY lamp will blink when the “Dry/Charge”
course is selected. •
ES-LF71_CIS.indb 8 2011/04/22 15:05:09