Инструкция по эксплуатации Panasonic ES-LF71

Страница 5

Advertising
background image

5



English

Charge

Chargingusingtheself‑cleaningrecharger

Thoroughly wipe off any drops of water on or around the self‑
cleaning recharger so that it is dry before charging the shaver.

1

1

Inserttheappliancepluginto
theself‑cleaningrecharger.

2

2

Removetheprotectivecapand
thenattachtheshaver.

3

3

PlugintheACadaptorintoa
householdoutlet.

1

3

2

The “Charge” course starts when attaching the shaver.
Turn the shaver off before attaching.
Check that the outer foil is not deformed or damaged when you
are attaching the shaver.
Wipe off any water droplets on the main body rear terminal.
You can charge even with the STATUS lamp of the self‑cleaning
recharger blinking.
Charging is completed after approx. 1 hour.

You can keep the shaver attached to the self‑cleaning recharger,
or connected to the AC adaptor, when not using it to maintain full
battery capacity. You cannot overcharge the shaver.

Chargingwithouttheself‑cleaningrecharger

You can also charge without the self‑cleaning recharger.

1

1

Inserttheapplianceplugintothe
shaver.

2

2

PlugintheACadaptorintoa
householdoutlet.

You cannot operate the shaver while charging.

Readinglampswhencharging

While charging

After charging is completed

The charge status lamp ( ) glows.

The number of the battery

capacity lamp will increase as

charging progresses.

All the lamps will light up and

then turn off after 5 seconds.

After charging is completed, turning the power switch ON with
the shaver plugged in will cause all the lamps to light up and then
turn off after 5 seconds. This shows that the shaver is fully
charged.
Recommended ambient temperature for charging is 5‑5 °C. The
battery may not charge properly or at all under extreme low or
high temperatures.
The charge status lamp ( ) will blink when there is a problem
with charging.
When charging the shaver for the first time or when it has not
been in use for more than 6 months, the charge status lamp ( )
may not glow. It will eventually glow if kept connected.

ES-LF71_CIS.indb 5

2011/04/22 15:05:08

Advertising