Bork IR NWV 3218 ** - Инструкция (Страница 27)

Instruction manual
27
After you have used all the water in the tank, you can pull the
steam control button further upwards to remove the steam control
needle. It is then possible to remove any scale from the needle.
For this purpose you may use vinegar. A
A A A Avoid bending or damaging void bending or damaging void bending or damaging void bending or damaging void bending or damaging
the steam contr the steam contr the steam contr the steam contr the steam control needle! ol needle! ol needle! ol needle! ol needle!
Replace the steam control needle. Insert the point of the needle
exactly in the center of the aperture and fit the small notch at the
side into the spacing.
Press the steam control button to check if it is exactly in place.
Set the steam control button to position “(no steam)”.
WARNING: DO NOT PUT VINEGAR, STARCH, CHEMICALLY DESCALED
WATER OR DESCALING AGENTS IN THE WATER TANK!
Af Af Af Af After self cleaning ter self cleaning ter self cleaning ter self cleaning ter self cleaning
Move the iron gently over a piece of cloth to remove water stain.
Cool down the iron for storage.
We recommend using the lowest temperatures with fabrics that have
unusual finishes (sequins, embroidery, flush, etc.).
If the fabric is mixed (e.g. 40% cotton 60% synthetics), set the
thermostat to the temperature of the fibre requiring the lower
temperature.
If you don’t know the composition of the fabric, determine the suitable
temperature by testing on a hidden corner of the garment. Start with
ADVICE FOR
GOOD IRONING
>