SIGMA BC 1606L - Инструкция (Страница 29)

General remarks Solving problems ╞ খ Generelle henvisninger ╝
We are liable to our contracting partners for
defects as defined by law. Batteries are excluded
from the guarantee. If you need to make a
guarantee claim, please contact the dealer
where you bought the bike computer. You can
also send the bike computer with your proof of
purchase and all accessories to the following
address. If you do so, please ensure adequate
postage.
Sigma Elektro GmbH
Dr.-Julius-Leber-Straße 15
D-67433 Neustadt/Weinstraße
Service-Tel. ++49-(0)6321-9120-118
E-Mail: [email protected]
If your guarantee claim is justified you will receive
a replacement device. You only have a right to
the current model at the time. The manufacturer
reserves the right to make technical changes.
Batteri:
1 litium knapcelle 2032, 3v
Batteriudskiftning vises i displayet.
Batteriudskiftning:
• HJULSTØRRELSER, TIDER HJUL 1+2
og TOTAL KM HJUL 1+2, SPROG,
KMH/MPH forbliver også gemt ved en
batteriudskiftning.
• Vær opmærksom på plus og minus,
ved åbnet batterirum skal PLUS-siden
vende opad!
• Læg pakningsringen i igen, hvis den er
løs.
• Efter en batteriudskiftning skal
klokkeslæt indtastes igen.
Garantien
Vi hæfter overfor vores pågældende
autoriserede forhandler for mangler iht.
de lovpligtige forskrifter. Batterier er ikke
omfattet af garantien.
Battery:
1 lithium button cell
2032, 3V
Battery change is
displayed on screen.
Change batteries:
• When the battery is changed the WHEEL
SIZE, LANGUAGE, KMH/MPH, TOTAL KM
and TOTAL TIME are saved and need not
be re-entered.
• Observe direction of plus and minus poles;
when the compartment is open you must
see the PLUS side of the battery!
• If sealing ring is loose, re-insert it.
• After changing the battery only the time
must be re-entered.
Data memory:
The data is written in the memory if:
• you quit the basic settings menu
• the BC enters sleep mode
KMH no display
• Old handlebar holder with radio transfer
(RDS) used?
• Casing pushed over magnet (cf. Fig. 9)?
• Computer correctly slotted into holder?
• Cable checked for breaks?
• Contacts checked for oxidation/corrosion?
• Distance between magnet and sensor (max. 5mm)
• Checked whether magnet is magnetized?
No display (screen blank)
• 2 magnets installed?
• Magnet positioned correctly?
• Wheel size set wrongly?
• Correct handlebar installed after bike changed?
KMH wrong display
Display black/changes slowly
• Temperature too high (>60°C) or too low (<0°C)
• Check battery
• Battery inserted correctly (plus and minus)
• Battery contact ok? (bend carefully!)
1_#_#,#
vbbm LOW
11:36