Binatone MHS-1105 - Инструкция (Страница 7)

7
ENGLISH
Recommendation: after styling is completed, apply a small
amount of a styling gel or mousse onto your hair,
smoothing it in the top-down direction.
2. Crimping attachment (7)
Take a lock and starting from the roots, begin waving this lock.
Keep the attachment on each lock for a few seconds. Exposure
time required depends on a type of your hair. To obtain continu-
ous wave put the attachment on the last row of a previous section.
To achieve sharper effect do not comb the hair after waving. For
smoother effect shake or comb hair to add volume.
3. Curling iron attachment (5)
The tighter hair will be wound around the rod the more elastic
will be locks. To obtain round curls take a small lock and wind it at
angle of 90° in respect of the scalp, move the tongs in such a
manner that the lock wound on the rod overlapping a previous
layer. In order to retain lock style longer, wind it on a finger
helically and hold it for some time till hair has cooled completely.
CARE AND CLEANING
1. Switch the appliance off by moving the switch
(2) to position “0”, and then unplug it from
the wall outlet and wait until it completely
cools down.
2. Clean the handle (1) and attachments with
a soft, lint free damp cloth. Do not allow wa-
ter or any other liquid get into the appliance.
3. If you are not going to use the appliance for some time, then
let it completely cool down, place it in the box and store in a
safe dry place out of reach of children.
4. The air intake grille must be cleared of any build-up of lint or
hair with a small brush.
AFTER-SALES SERVICE
If your appliance does not operate or
does not operate properly, contact an au-
thorized service center for consultancy or
repair.
The warrantee does not cover:
– product packing, consumables and ac-
cessories (knives, disks, tips, etc.);
– mechanical damages and natural wear of the product;
– failures due to overloading, improper or careless maintenance,
penetration of liquids, dust, insects and other foreign matters
inside the product, exposure of plastic and other not thermal-
resistant components to high temperatures, force-majeure cir-
cumstances (accidents, fire, flooding, power grid failure, light-
ning stroke, etc.);
– damages caused by:
! Non-fulfillment of the above-mentioned precautions and op-
erating manuals.