Binatone HB-7333 - Инструкция (Страница 7)

7
ENGLISH
3. Install appropriate mincer blade (10) into the bowl (11, 12).
4. Place products into the mincer bowl (11, 12).
5. Install the mincer gear (8) on the bowl (11, 12).
6. Place the body of appliance (1) on mincer gear (8). Align appro-
priate openings in the body (1) and in the mincer gear (8).
7. Prior to switching on the appliance, make sure that the gear
(8) is properly installed!
8. Plug the appliance into mains.
9. Set desired speed using speed selector (2) and push switch
button (3,4) to turn on the appliance. Keep the button pressed
while the appliance is operating.
10.Unplug the appliance from mains after use.
Shredder and slicer (,13,14)
1. Tip for slicing (13) is applied for slicing products in circles.
2. Shredder (14) is applied for shredding as well as for grating
products in strips.
3. Insert the available replaceable tip (13, 14) which you would
like to use, into the cover for attachments (15) by pressing the
longer side section of the tip. Place the cover (15) on the core
inside the bowl (12).
Note: put the selected tip (13, 14) with the cutting part
upward.
4. Press the fixing knob (18) on the bowl handle. Put the lid (17)
on the bowl (12). Fix the lid (17) so as the ledges on the bowl
(12) get inside the grooves on the lid (17). Turn it counter
clockwise keeping fixing knob (18) pressed. The ledge on the
lid (17) should get inside the hole in the fixing knob (18).
Make sure you install the bowl (12) or the lid (17) properly. If
you don’t install it correctly, the appliance won’t work.
5. Attach the body (1) to the appropriate opening on the lid
(17). Place the pusher (16) in the feeding tube of the lid
(17). Plug the appliance into mains.
6. Set desired speed using speed selector (2) and push switch
button (3,4) to turn on the appliance. Keep the button pressed
while the appliance is operating.
7. Unplug the appliance from mains after use.
8. Use mode «1-5» for grating and slicing solid product. Use
mode «Turbo» for soft products.
9. Large products should preliminary be cut into smaller pieces, so
that they could easily pass through the food loading opening.
Attention : be extremely careful when use the attachments
(13, 14) and chopper (10). The knife blades are
very sharp! Be extremely careful while removing the
attachments.