Binatone SI-4024 - Инструкция (Страница 7)

7
ENGLISH
Attention: Application of the steam ironing function is
impossible at «•» temperature setting. The «Drip
Stop» system automatically terminates the steam
generation process if the selected temperature is too
low. When the system is activated, you may hear a
light click.
Turbo steam
To ease ironing of dense cotton, linen and upholstery articles
use the steam burst button (8): engagement of the button (8)
during the ironing process generates an extra burst of steam from
the sole plate to help remove stubborn creases.
Burst of steam in a vertical position
This function helps to freshen the appearance of curtains, jack-
ets, coats, etc. To use this function, take the following steps:
! Follow instructions in paragraph 1-4 of the section «Operation
instructions». While selecting the temperature setting, put the
temperature control knob (10) into the «Max» position.
! While holding the iron in a vertical position, aim its sole plate
towards the articles to be ironed and push the steam burst
button (8) to produce a directional strong burst of steam from
the sole plate. Push the button several times with 5-7 seconds
intervals until the article is fully refreshed. If during the process
your water tank (5) runs out of water, disconnect the appli-
ance from the mains outlet, wait till it cools down, refill the tank
and plug the appliance back into the power supply and con-
tinue the process.
Spray
Using the water spray (7) will help when ironing details of the
article (cuffs, trimmings, plackets, etc) or clothes, which demand
«•» (low temperature) ironing, when steam ironing is not pos-
sible. Push the button several times to moisten the material.
Auto shut-off function (for SI-4022)
For safety reasons, your iron will automatically switch off if it’s
left without supervision:
! upright for more than 8 minutes, or
! flat for more than 30-35 seconds.
The operation indicator (11) will start blinking.
The iron will switch on again, when you move it. After that the
operation indicator will stop blinking.
5. When you have finished cleaning or ironing, do not forget to
switch the iron off by putting the steam control knob (9) into
the «0» position, the temperature control knob (10) – to the
minimal position and unplugging the appliance from the mains
supply outlet.