Инструкция по эксплуатации ZELMER 28Z019
Страница 82
82
GW28-029_v02
Control light goes off when the required temperature is reached. The
–
iron is now ready for use.
Move the
–
Steam Control Knob (7) to selected position, in order to set
the amount of steam.
After finishing move the
–
Temperature Dial (2) in anti-clockwise
direction to „
MIN”; the iron is switched off.
Move the
–
Steam Control Knob (7) to position.
Disconnect the iron from mains supply outlet.
–
When the iron gets cool completely, store it vertically in a safe place.
–
Burst of steam
– Always follow the garment manufacturer’s
ironing instructions mentioned at the garment label.
This function provides extra amount of steam which can be used for
ironing very wrinkled (crumpled) clothes.
Unwind and straighten the
–
power cord (13).
Fill the water tank in as described under “How To Fill Water”.
–
Connect the iron to a suitable mains supply outlet.
–
Turn the
–
Temperature Dial (2) in clockwise
direction to ●●● position. See preparation for
operation.
Control light (11)
–
glows, indicating that the
iron is on.
Control light goes off when the required
–
temperature is reached. The iron is now
ready for use.
Press the
–
Burst of Steam Button (9) once
– steam will shoot from the holes of the
soleplate.
For stubborn wrinkles, wait a few seconds before pressing the Burst of
–
Steam Button (9) again. Most wrinkles can be removed within three
presses.
After finishing move the
–
Temperature Dial (2) in anti-clockwise
direction to „
MIN”; the iron is switched off.
Move the
–
Steam Control Knob (7) to position.
Disconnect the iron from mains supply outlet.
–
When the iron gets cool completely, store it vertically in a safe place.
–
ATTENTION:
It may be necessary to press the burst of steam button a few times
to start this function.
For optimum steam quality, do not operate the Burst Of Steam more
than three times after the pilot light goes off.
Burst of steam in vertical position
– Always follow the garment
manufacturer’s ironing instructions mentioned at the garment label.
This function provides extra amount of steam to remove wrinkles
on delicate garments in hanging position, hanging curtains, or
other hanging fabrics.
Warning:
Do not apply steam on any clothes or fabrics that are being worn by
human or pets. Temperature of steam is very high. Never direct the
steam to human or pets.
Fill the water tank in as described under “How To Fill Water”.
–
Connect the iron to a suitable mains supply outlet.
–
Turn the
–
Temperature Dial (2) to ●●●
position. See „Preparation for operation“.
Control light (11)
–
glows, indicating that
the iron is on.
Control light goes off when the required
–
temperature is reached. The iron is now
ready for use.
Hold the iron between 15 and 30
–
centimetres away from the garment.
Press the
–
Burst of Steam Button (9) once – steam will shoot from the
holes of the soleplate.
For stubborn wrinkles, wait a few seconds before pressing the
–
Burst
of Steam Button (9) again. Most wrinkles can be removed within
three presses.
After operation turn the
–
temperature dial knob (2) in counter clockwise
direction to „
MIN” position. The iron is switched off.
Lock the iron with stand as described in “How to Use Iron Lock”.
–
Move the
–
Steam Control Knob (7) to position.
Disconnect the iron from mains supply outlet.
–
When the iron gets cool completely, store it vertically in a safe place.
–