Siemens Gigaset C59H - Инструкция (Страница 103)

43
Customer Service & Assistance
Gigaset C59H / IM5 EN / A31008-M2150-S301-2-9U19 / appendix.fm / 17.05.2010
V
e
rsion 4, 16.0
9
.2005
Questions and answers
If you have any queries about the use of your
telephone, visit our website at
www.gigaset.com/customercare
for assistance 24/7.
For information about interception safety,
go to
www.gigaset.com/de/dect-sicherheit.
The table below contains a list of common
problems and possible solutions.
The display is blank.
1. The handset is not switched on.
¥
Press and hold the end call key
a.
2. The battery is empty. ¥
Charge the battery or replace it
( ¢
page 9).
Not all menu options are displayed.
The menu display is reduced (Standard mode).
¥
Activate extended menu display
(Expert mode
•
) (
¢
page 23).
No Base
flashes on the display.
1. The handset is outside the range of the base. ¥
Move the handset closer to the base.
2. The range of the base is reduced because Eco
mode is activated. ¥
Deactivate Eco mode (
¢
page 35) or
reduce the distance between the handset
and the base.
3. The base is not switched on. ¥
Check the power adapter of the base.
Please register handset flashes on the display.
Handset has not been registered with the base or
has been deregistered.
¥
Register the handset (
¢
page 11).
Handset does not ring.
1. The ringtone is deactivated.
¥
Activate the ringtone (
¢
page 40).
2. Call divert set for "All Calls". ¥
Deactivate call divert (refer to base user
guide).
3. The telephone only rings when the phone
number is transmitted. ¥
Switch on the ringtone for anonymous
calls ( ¢
page 40).
The other party cannot hear you.
You have pressed the mute key
h. The handset
is "muted". ¥
Reactivate the microphone (
¢
page 27).
You hear an error tone when keying an input (a
descending tone sequence).
Action has failed/invalid input. ¥
Repeat the operation.
Watch the display and refer to the user guide
if necessary.
Exclusion of liability
Some displays may contain pixels
(picture elements), which remain acti-
vated or deactivated. As a pixel is made
up of three sub-pixels (red, green, blue), it
is possible that pixel colours may vary.
This is completely normal and does not
indicate an error.