Beko WMI 71241 - Инструкция (Страница 26)

26 EN
6 Maintenance and cleaning
Service life of the product extends and
frequently faced problems decrease if
cleaned at regular intervals.
Cleaning the detergent drawer
Remove any powder residue buildup in
the drawer. To do this;
1
2
3
4
1. You can remove the detergent drawer
by pulling it towards yourself strongly.
C If more than a normal amount of
softener and liquid detergent mixture
starts to remain in the softener
compartment, the siphon must be
cleaned.
2. Wash the drawer and the siphon
with plenty of lukewarm water in a
washbasin. Wear protective gloves
or use an appropriate brush to avoid
touching the residues in the drawer
when cleaning.
3. Replace the drawer into its housing
after cleaning. Check if the siphon is
in its original location.
Cleaning the loading
door and the drum
Residues of softener, detergent and
dirt may accumulate in your machine in
time and may cause unpleasant odours
and washing complaints. To avoid this,
use the Drum Cleaning programme. If
your machine is not featured with Drum
Cleaning programme, use Cottons-90
programme and select Additional Water
or Extra Rinse auxiliary functions as
well. Before starting the programme,
put max. 100 g of powder anti-
limescale into the main wash detergent
compartment (compartment nr. II). If
the anti-limescale is in tablet form, put
only one tablet into compartment nr. II.
Dry the inside of the bellow with a clean
piece of cloth after the programme has
come to an end.
C Repeat Drum Cleaning process in
every 2 months.
C Use an anti-limescale suitable for
the washing machines.
After every washing make sure that no
foreign substance is left in the drum.
If the holes on the bellow shown in the
figure is blocked, open the holes using
a toothpick.
C Foreign metal substances in your
machine will cause rust stains.
Clean the stains on the drum
surface by using cleaning agents for
stainless steel. Never use steel wool
or wire wool.
Cleaning the body
and control panel
Wipe the body of the machine with
soapy water or non-corrosive mild gel
detergents as necessary, and dry with a
soft cloth.
Use only a soft and damp cloth to clean
the control panel.
A Never use sponge or scrub
materials. These will damage the
painted and plastic surfaces.