Инструкция по эксплуатации Elenberg WM-3610M
Страница 16
16
1. Loading the machine
Open the door and place the laundry in the drum, then close the
door firmly; the machine will not start if the door is not closed
properly.
2. Selecting washing programme
Choose the programme according to the type of fabric you are go-
ing to wash by referring to the programme list.
Attention: Never turn the button anticlockwise!
Turn the button so that the arrow points to the programme re-
quired; never point the arrow between two programmes.
3. Selecting washing temperature
Turn the temperature dial to the required position. If you want a
cold wash leave the button in the «0» position.
Do not exceed 40°C in the wool programme.
4. Selecting the function
If necessary, activate the special function button according to the
control pane.
N.B.: ANY FUNCTION BUTTONS THAT ARE NOT ACTIVATED MUST BE
IN THE NEUTRAL POSITION.
5. Dosing and adding washing products
Put the detergent and other products in the correct compartments.
Compartment 1 is used for washing powder, compartment 2 for
fabric softeners, whiteners, stain removers etc. When using pro-
grammes 1, 2 and 3, the fabric softener is run in during the first
rinsing cycle to produce an anti-allergenic effect. If you want a
classic fabric softener rinsing cycle, pour the fabric softener into
compartment 2 and start the programme again in position 4. Make
sure you use a good quality detergent to avoid excessive foam.
6. Filling and starting the machine
Turn the water tap on full and check that there is no leaking.
Press the ON/OFF button to start the machine; it will run automati-
cally until the end of the cycle.
The machine will stop when the programme dial reaches the “ЃњЃh
position.
7. Unloading the machine
Press the ON/OFF button to set to the STOP position. Wait for two
minutes then push the button to open the door; remove the gar-
ments.
USING THE MACHINE