Vitek VT-2632 - Инструкция (Страница 4)

4
ENGLISH
knowledge if they are not under supervision of
a person who is responsible for their safety or
if they are not instructed by this person on the
usage of the unit.
• Do not leave children unattended to prevent
using the unit as a toy.
• During operation and breaks between opera-
tion cycles, the unit should be placed out of
reach of children.
• For children safety reasons do not leave poly-
ethylene bags, used as packaging, unat-
tended.
Attention! Do not allow children to play with
polyethylene bags or packaging film. Danger
of suffocation!
• Never use the unit if the power cord or the
power cord plug is damaged, if the unit works
improperly or after it was dropped.
• Do not attempt to repair the unit. Do not disas-
semble the unit, if any malfunction is detected
or after it was dropped, unplug the unit and
apply to any authorized service center from
the contact address list given in the warranty
certificate and on the website www.vitek.ru.
• Transport the unit in the original package only.
• Keep the unit out of reach of children and dis-
abled persons.
THIS UNIT IS INTENDED FOR HOUSEHOLD
USAGE ONLY
BEFORE THE FIRST USE
In case of the unit transportation or storage under
cold (winter) conditions, it is necessary to keep it
for at least three hours at room temperature.
– Before switching the unit on for the first time,
make sure that the mains voltage corresponds
to the voltage specified on the unit body.
– Unpack the press grill and remove all package
materials, wipe the grill body with a slightly
damp cloth and then wipe it dry.
– Open the grill, press simultaneously on the
two lower frying plate locks (7) and remove
the lower frying plate (5), simultaneously
press on the locks (2) and remove the upper
frying plate (3).
– Wash the frying plates (3 and 5) with warm
water and neutral detergent and dry them
thoroughly.
– Install the frying plates back to theirs places;
to do this, match the ledges on the frying
plates (3 and 5) with the grooves on the rear
locks (10) and press alternately on the front
part of the frying plates (3 and 5) until the
locks (2 and 7) clicking.
– Before using the grill apply some vegetable oil
on the non-stick coating of the frying plates (3
and 5), spread the oil over the whole surface
and wipe the surplus oil with a paper napkin.
– Close the grill, insert the power plug into the
socket, the power indicator (8) will light up.
– Set the temperature control knob (9) to the
maximal heating position «3».
– After 5-10 minutes switch the unit off by set-
ting the temperature control knob (9) to the
position «1» and unplug the unit.
– Wait until the frying plates (3 and 5) cool down
completely and remove the remaining vegeta-
ble oil with a paper napkin.
Note: While the first unit operation the heating
elements burn, therefore occurrence of a small
amount of smoke or foreign smell is possible.
It is normal and is not a sign of malfunction.
FOOD COOKING WITH THE GRILL
– Place the grill on a flat, stable surface away
from sources of moisture, heat and open
flame and with free access to the mains
socket.
– Do not place and do not use the grill near
highly inflammable objects or liquids and
objects subject to thermal deformation.
– Use the unit in places with proper ventilation.
• Make sure that the frying plates (3 and 5) are
installed and fixed.
Attention! Do not switch the grill on without the
frying plates (3 and 5) installed.
• Oil the non-stick coating of frying plates (3
and 5) slightly and close the grill.
• Place a container (12) under the chute for
draining fat (6).
• Insert the power plug into the socket, the
power indicator (8) will light up.
• Turn the temperature control knob (9) to set
the required heating temperature of the frying
plates (3 and 5) (see the recommendations
in the table).
• After 5-10 minutes the frying plates reach the
preset temperature and you can start cook-
ing.
• Take the handle (1) and open the grill.
• Carefully put the products on the lower fry-
ing plate (5). Avoid getting burns by splash-
ing liquids or fat.
IM VT-2632.indd 4 17.08.2016 16:54:09