Инструкция по эксплуатации Saturn ST-CC0210
Страница 2
2
3
GB
IRON
Dear Buyer!
We congratulate you on having
bought the device under trade
name “Saturn”. We are sure that
our devices will become faithful
and reliable assistance in your
housekeeping.
Avoid extreme temperature
changes. Rapid temperature
change (e.g. when the unit is
moved from freezing temperature
to a warm room) may cause
condensation inside the unit and a
malfunction when it is switched
on. In this case leave the unit at
room temperature for at least 1.5
hours before switching it on.
If the unit has been in transit,
leave it indoors for at least 1.5
hours before starting operation.
Please, read these instructions
carefully and familiarize yourself
with your new dry spray iron
before first use.
1.
Handle
2.
Body
3.
Heat insulating plate
4.
Soleplate
5.
Temperature dial
6.
Indicator light
7.
Power cord
IMPORTANT SAFEGUARDS
PLEASE READ CAREFULLY –
ALWAYS MAINTAIN SAFETY,
WHEN WORKING WITH ANY
APPLIANCE.
· Check that the mains voltage
corresponds with the rating of the
appliance before operating.
· Do not touch hot surfaces – use
handles or knobs.
· To protect against electric shock, do
not immerse cords, plugs or
appliances in water or any other
liquid.
· Do not leave any appliance
unattended, while it is operating.
· Close supervision is necessary when
any appliance is used by or near
children or infirm persons.
· Unplug from outlet when not in use
or before cleaning. Allow to cool
before putting on or taking off any
parts.
· Do not operate the appliance with a
damaged cord or plug or after the
appliance has been damaged in any
manner. If the supply cord or
appliance is damaged, it must be
replaced by the manufacturer or its
service agent or a similarly qualified
person in order to avoid a hazard.
· Do not let the cord hang over the
edge of a table or counter or let it
come into contact with any hot
surfaces.
· Do not use this product for anything
other than its intended use. This
appliance is for household use only.
· No liability can be accepted for any
damage, caused by noncompliance
with these instructions or any other
improper use or mishandling.
· The iron should always be turned to
“min” before plugging or unplugging
from the mains outlet. Never pull the
cord to disconnect from the mains:
instead, grasp plug and pull to
disconnect.
· Burns can occur from touching hot
metal parts, hot water or steam, use
caution when you turn a steam iron
upside down – there may be hot water
in the reservoir.
· If the iron is not operating normally,
disconnect from the power supply and
contact the nearest authorized service
agent.
· Your iron is designed to rest on the
heel. Do not leave the iron unattended
when switched on. Do not place the
iron on an unprotected surface even if
it is on its heel rest.
OPERATION
DRY IRONING
The iron heats up faster, than it
cools down. Therefore, begin by
ironing the items, that require a lower
temperature (synthetic fibre and silk)
and then iron items of material that
requires a higher heat (wool, cotton,
jute, etc.)
Insert the plug into the electrical
outlet. Turn the temperature control to