Saturn ST-CC7109 - Инструкция (Страница 2)

2 3
GB
IRON
Dear Buyer!
We congratulate you on having
bought the device under trade
name “Saturn”. We are sure that
our devices will become faithful
and reliable assistance in your
housekeeping.
Avoid extreme temperature
changes. Rapid temperature
change (e.g. when the unit is
moved from freezing temperature
to a warm room) may cause con-
densation inside the unit and a
malfunction when it is switched
on. In this case leave the unit at
room temperature for at least 1.5
hours before switching it on.If the
unit has been in transit, leave it
indoors for at least 1.5 hours be-
fore starting operation.
IMPORTANT SAFETY INSTRUCTIONS
When using your flatiron, basic safety
precautions should always be followed,
including the following:
READ ALL INSTRUCTIONS BEFORE
USING
1. Use iron only for its intended use.
2. To protect against a risk of electric
shock, do not immerse the iron in water
or other liquids.
3. The iron should always be turned to
Off before plugging or unplugging
from outlet. Never yank cord to discon-
nect from outlet; instead, grasp plug
and pull to disconnect.
4. Do not allow cord to touch hot sur-
faces. Let iron cool completely before
putting away. Loop cord loosely around
iron when storing.
5. Always disconnect iron from electrical
outlet when filling with water or empty-
ing and when not in use.
6. Do not operate iron with a damaged
cord or if the iron has been dropped or
damaged. To avoid the risk of electric
shock, do not disassemble the iron take
it to a qualified serviceman for examina-
tion and repair. Incorrect reassembly
can cause a risk of electric shock when
the iron is used.
7. Close supervision is necessary for any
appliance being used by or near chil-
dren. Do not leave iron unattended
while connected or on an ironing board.
It is not advised to use this appliance by
children under 14.
8. Burns can occur from touching hot
metal parts, hot water, or steam. Use
caution when you turn a steam iron
upside down – there may be hot water
in the reservoir.
9. If the malfunction indicator goes on,
the flatiron is not operating normally.
Disconnect from the power supply and
have the flatiron serviced by qualified
service personnel.
SPECIAL INSTRUCTIONS
1. To avoid a circuit overload, do not
operate another high wattage appliance
on the same circuit.
2. If an extension cord is absolutely
necessary, a 10-ampere cord should be
used. Cords rated for less amperage
may overheat. Care should be taken to
arrange the cord so that it cannot be
pulled or tripped over.
SAVE THESE INSTRUCTIONS.
More specifically:
DO NOT let children or untrained per-
sons use the appliance without supervi-
sion.
NEVER immerse the iron, cable or plug
in any liquid.
DO NOT leave the hot iron touching fab-
rics or very inflammable surfaces.
DO NOT leave the appliance unneces-
sarily plugged in. Disconnect the plug
from the mains when the appliance is
not being used.
NEVER touch the appliance with wet or
damp hands.
DO NOT use the power cord or the ap-
pliance in order to pull the plug out of
the socket.
DO NOT leave the appliance exposed to
the weather (rain, sun, etc. ).
DO NOT leave the iron without supervi-
sion when it is connected to the power
supply.
DO NOT fill the reservoir with water
before removing the plug from the
socket.
PLEASE NOTE!
Do not use chemical additive, scented
substances or decalcifiers. Failure to
comply with the above-mentioned regu-
lations leads to the loss of guarantee.
DESCRIPTION OF DEVICE
(1). Spray organ
(2). Filler door
(3) Steam dial
(4). Spray button
(5). Shot-steam button
(6). Auto shot off indication light
(7). Supply cord
(8). Cord bushin
(9). Transparent water tank
(10). Thermostat knob for temperature
regulation
(11). Self-cleaning button
(12). Plate with steam vents
(13). Maximum filling level
(14). Water measure