Vitek VT-1351 - Инструкция (Страница 3)

26
ENGLISH
3
BLADE ALIGNMENT
Your clippers were carefully examined to ensure
that the blades were oiled and aligned before leav
ing our factory.
Blades must be realigned if they have been
removed for cleaning or replacement.
To realign the blades, simply match the upper and
bottom blades teeth up, point for point.
(End of top blade teeth should be approximately
1.2mm back from bottom blade. Compare your
clipper blades with the sketch.)
If blade alignment is incorrect, add a few drops of
oil to the blades, turn clipper on for a few moments,
turn off and unplug. Loosen
screws slightly and adjust.
Tighten screws after blade is
aligned.
OIL
To maintain your clipper in peak condition, the
blades should be oiled every few haircuts.
Do not use hair oil, grease, oil mixed with kerosene
or any solvent. As the solvent will evaporate and
leave the thick oil which may slow down the blades
motion.
1351new.qxd 22.10.02 17:55 Page 6