TIMBERK THU UL 04 - Инструкция (Страница 14)

O Important!
1. To prevent an electric shock, prior to dismantling the device
(removing the tank), unplug the device from electric mains! 2. Do
not fill the tank with liquids other than tap water.
Other composition of liquids has an adverse effect on internal
parts and results in a failure.
3. Do not fill the device or the water tank with such additives as
essential oil, flavoring substance, detergent, chemical medical
products, warm water (over 40°), etc.
Otherwise the water tank and internal parts of the unit will be
damaged and be broken.
4. Do not fill water directly into the internal part of the unit or the
atomizer.
Water inside the unit may result in failure of the device.
5. Do not hit and do not throw the water tank. It can be damaged
which will result In water leakage. Do not use the unit in case the
tank is heavily hit.
Contact a maintenance service or maintenance and repair station
immediately.
6. Every day fill the tank with pure water and keep the unit clean.
6. Operation of the unit
6.1 Switching on the unit
Connect the unit to electric mains. Fill the tankwith water in advance.
A musical signal will be given when the unit is connected to a power supply
source.
Press "On/Off" button (Power, On/Off), a musical signal will be given and
the unitwill automatically start operating.
"AUTO" mode will be shown on the display screen and steam will start
coming out of the atomizer.
The display screen will show current air humidity and the warm atomizing
mode will be switched on automatically.
Ten seconds after pressing the power button a light atomizing Indicator
(preparation for operation) will be Illuminated and then will goout.
At the very beginning of this operation the atomizing level could seem
unstable which is caused bythetemperaturedifferenceand waterquallty.
It will take some time for water to transform into steam inside the
atomizer's nozzle and this process to be stabilized. In 10-25 minutes of
operation the atomizing level will be gradually stabilized.
Heat! ng of steam wi 11 ta ke about 10-20 m I ñutes.
important!
At first or repeated use of the unit even with full tank the water level
indicator, showing there is no water, will be Illuminated on the display
screen. It happens due to the fact that it takes some time for water to flow
from the tankto a water groove.
The unitwill automatically startoperating In 2-5 minutes.
In case If all water In the tank is used, the unitwill be switched off and a
sound signal will be given prior to It and the"waterleverindicator will be
Illuminated. In five seconds the light indicator will go out and a red light
will be illuminated.
Add water In accordance with the manual forfurther use of the unit.
6.2 Automatic operation mode
A temperature and humidity sensor Is installed Inside the humidifier, when
the unit Is switched on or the automatic operation mode is selected It
allows
the unit to Independently achieve the most favorable
humidification level depending on room airtemperatureand humidity.
Table 2.
Room air temperature
Setting of the automatic operation mode
(level of favorable humidity)
<19“C 65%
20-2VC
60%
22-24X
55%
>25X.
50%
In the automatic mode the atomizing level Is set in accordance with the
difference between levels of measured and nominal humidity. The
atomizing level in automatic mode:
Table 3.
Difference between levels of Atomizing frequency
favorable and current humidity (intensity indicator)
>16 Intensive mode (maximum power)
15^ Moderate mode (normal power)
<3 Light mode (low power)
Current humidity level
exceeds the favorable one
automatic switching off
www.timberk.nj • ultrasonic humidifier